© 2001 PANORAMAdtv ALL rights reserved10MON3-2A User Manual P/N 821521 Rev-B.5Please refer to Figure-2b on the following page to familiarize yourself with the front panel features of the MON3-2A unit. The following sections describe these features and are referenced, by number, to Figure-2b.Note: Descriptions of items 2 through 6 apply to each one of the three monitor sections (1 - 3).Front Panel FeaturesSection 2: Operation1 Power Indication - Green LEDThe Power Indicator glows green when mains power is connected to the MON3-2A. Individualdisplay power switches (Item E, page 12), located on the rear panel control the on/off operation of each ofthe three associated displays.2 LCD Video Monitor - TFT ScreenView input video sources here. Select source inputs by setting the Input (I/P) Selector Switch (Item 5,below) to the desired input. Screen image parameters are adjustable by four manual controls (Item 3,below).3 LCD Video Monitor Display Controls - Rotary Trim PotsEach LCD video monitor can be adjusted separately using these four image controls:• TINT - Tint; adjust for desired image color hue (NTSC only).• CHROMA - Color Saturation; adjust for desired amount of image color saturation.• BRIGHT - Brightness; adjust for desired screen brightness.• CONT - Contrast; Adjust for desired image scene dark-to-bright contrast.4 PAL/NTSC Indication - Yellow LEDThis indicator shows the detected signal type connected to the CVBS input connector. This LEDglows yellow to indicate a PAL encoded signal is connected. This LED remains dark to indicate anNTSC signal is connected.5 Input (I/P) Selection - Toggle Switch (MSDI-1 SDI Option)This switch selects analog composite video (CVBS) or the SDI digital component video inputsignals connected to the rear panel. (SDI sources require the MSDI-1 SDI option.) The Input (I/P)Selector Switch selects these signals according to the following switch positions:• UP (B): SDI digital component signal.• DOWN (A): CVBS analog composite signal.6 Tally Indication - Tri-color LEDThis tri-color LED can glow red, green, or yellow to indicate tally status associated with thesignal displayed. Refer to page 18 for tally connection details.7 Video Section Label - BlankUse these blank areas to apply labels or write in names for each of three video control sections applicable to yourneeds.