Pantech Burst User Manual

Also see for Burst: Quick start guide User guide Manual

Contents

Pantech Burst User Manual Manual pdf 30 page image

303. Call & MessageCallingMaking a call1. Tap Phone from the launcher.2. Enter an area code and a phonenumber.3. Tap .Note Tap to delete. Tap and hold todelete the whole number.Phone main displayAnswering and ending a call1. Drag to the right to answer a call.2. Tap to end a call duringconversation. After ending a call, itssummary is shortly displayed.Incoming callRejecting a call1. Drag into the circle to reject a call.Note You can also send a message before rejecting a call bydragging into the circle.Adjusting the volume1. Press the upper volume key to increase the volume during acall.2. Press the lower volume key to decrease the volume during acall.Notex Press the volume key in idle mode if you want to adjust the ringtonevolume. If you want to set it to the vibrate mode, press the volumekey all the way down until the mode appears.x You can disable or enable the noise suppression function duringa call. Tap > Noise suppression. Tap On or Off to turn on or offthe speaker. For more information about the noise suppressionfunction, refer to “Setting Noise Suppression” on page 77.Holding and unholding a call1. Tap during a call. The party will hear nothing.2. Tap to resume the call.3. Tap to finish the call.Swapping a call for a multiparty call1. The first party will hear a waiting sound.2. Tap to change the calling party.3. Tap to finish the call.Making a conference call1. Tap Phone from the launcher.2. Enter an area code and a phone number.3. Tap Add call to invite a third party to the call.4. Tab Merge calls to make conference.