Pantech C3b User Manual

Contents

Pantech C3b User Manual Manual pdf 96 page image

95FCC & Industry Canada Regulatory ComplianceFCC & Industry Canada Regulatory ComplianceThis device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) thisdevice may not cause harmful interference, and (2) thisdevice must accept any interference received, includinginterference that may cause undesired operation.Your mobile device is a low power radio transmitter andreceiver. When it is ON, it receives and also sends outradio frequency (RF) signals. In August 1996, the FederalCommunications Commission (FCC) adopted RF exposureguidelines with safety levels for mobile devices. Thoseguidelines are consistent with safety standards previouslyset by both U.S. and international standards bodies:American National Standard Institute (ANSI), NationalCouncil of Radiation Protection and Measurements(NCRP),and International Commission on Non-Ionizing RadiationProtection (ICNRP). Those standards were based oncomprehensive and periodic evaluations of the relevantscientific literature. The design of your Phone complies withthe FCC guidelines and applicable.Statement according to FCC part 15.105Statement according to FCC part 15.21Modifications not expressly approved by this companycould void the user's authority to operate the equipment.RF exposure FCCFor body worn operation, to maintain compliance with FCCRF exposure guidelines, use only accessories that containno metallic components and provide a separation distanceNOTE This equipment has been tested and found to comply withthe limits for a Class B digital device, pursuant to Part 15 of the FCCRules. These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energyand, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turningthe equipment off and on, the user is encouraged to try to correctthe interference by one or more of the following measures:•Reorient or relocate the receiving antenna.•Increase the separation between the equipment and receiver.•Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.•Consult the dealer or an experienced radio/TV technician forhelp.070209_C3B_EN.indd 95 2007.2.9 2:38:47 PM