173AppendixYour mobile device is a low power radio transmitter and receiver. When it is ON, itreceives and also sends out radio frequency (RF) signals. In August 1996, the FederalCommunications Commission (FCC) adopted RF exposure guidelines with safety levelsfor mobile devices. Those guidelines are consistent with safety standards previously set byboth U.S. and international standards bodies: American National Standard Institute (ANSI),National Council of Radiation Protection and Measurements (NCRP), and InternationalCommission on Non-Ionizing Radiation Protection (ICNRP). Those standards were based oncomprehensive and periodic evaluations of the relevant scientific literature. The design ofyour phone complies with the FCC guidelines.Statement according to FCC part 15.105Note: This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, the useris encouraged to try to correct the interference by one or more of the following measures:x Reorient or relocate the receiving antenna.x Increase the separation between the equipment and receiver.x Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.x Consult the dealer or an experienced radio/TV technician for help.Statement according to FCC part 15.21Modifications not expressly approved by this company could void the user’s authority tooperate the equipment.