ParaZero SafeAir M200 Installation Manual

Also see for SafeAir M200: Instructions

Contents

ParaZero SafeAir M200 Installation Manual Manual pdf 13 page image

SafeAir™ M200 Installation Guide 13 www.parazero.com14 Pull the safety pin out all the way. The system powers up. During power-up, the SafeAirM200 LED displays solid YELLOW.15 After a few seconds, a single short beep is heard and that the SafeAir M200 LED on theparachute system changes to BLUE.You are now cleared for take-off!3.6 Takeoff and Landing1 When climbing, you must climb to approximately eight meters before the system isarmed. Climb until you hear a single long beep and the LED is GREEN.2 The system is now armed and ready for activation in case of an emergency.3 When approaching landing, at approximately three to five meters from the takeoffaltitude, the parachute system automatically disarms. At that point, a long double-beepis heard and the LED is PURPLE.If the landing point is at a different altitude than the takeoff altitude, or the system did notdischarge for some reason in the air, which may occur when there is a sudden change inatmospheric pressure, land the drone slowly while keeping it level. After three seconds,the system on the ground disarms itself.4 After the disarm indication appears, insert the safety pin all the way in before touchingthe drone.CautionWhen approaching the system, always keep your head down.5 Place the safety cover back on the system.The system is now safe and secured.