Paradyne 3800 User Manual

Also see for COMSPHERE 3800 Series: Supplement manual Firmware update Quick reference Release note Firmware update guide

Contents

Paradyne 3800 User Manual Manual pdf 114 page image

Configure Branch9-453810-A2-GB30-30 September 1998Security ConfigurationOptionsThe Security Configuration Options group allows youto view and set dial access security parameters. Thisgroup appears only if the dial access security feature hasbeen installed.Table 9-9 shows each Security configuration option asit appears on the LCD. The factory default value is shownafter the colon (:) on the first line; all available selectionsare listed on the second line. After this, a description ofthe each selection follows. These configuration options donot have an equivalent AT command.Table 9-9(1 of 2)Security Configuration Options*EntryWait_Time: 20 secNxt 20 sec 10 sec 40 sec 60 secEntry Wait Timeout. Determines how long the answering modem waits for the originating modem to enter a VF-sidepassword and DTE-side password.This timer resets for each phase of access security. For example, if a VF-side password and a DTE-side password arerequired, then the user has 20 seconds per entry to input the correct password.The factory default is 20 seconds.VF_Prompt_Type: 2nd_DialToneNxt 2nd_DialTone Quiet_AnswerVF Prompt Type. Determines how the answering modem requests a valid password from the originating modem for thevalid password. This configuration option is only used for VF-side password entry and is not valid for DTE-side passwordentry.NOTE: This configuration option only appears if the Answer Security Mode configuration option is configured forVF_&_DTE.2nd Dial Tone – Once the answering modem is off-hook, it generates a dial tone to the originating modem as a promptfor that modem’s VF-side password. (Second dial tone is represented by a W in the dial command string.)Quiet Answer – Once the answering modem is off-hook, it does not send an answer tone to the originating modem. Theoriginating modem enters its VF-side password after detecting a ring back signal followed by five seconds of silence. Forthis to work correctly, the Auto Answer Ring # configuration option in the answering modem must be set to 2 rings orgreater. (Quiet answer is represented by an @ in the dial command string.)The factory default is 2nd_DialTone.*#DTE_PW_Tries: 1Nxt 1 2 3 4 5Number of DTE Password Tries. Determines the number of attempts an originating user has to enter a valid DTE-sidepassword. If the password entered does not match a value in the answering modem’s Password Table, then the modemwill issue the password prompt again (provided that the number of tries is set to a value greater than 1). This willcontinue until the correct password is entered by the originating user or the number of tries allowed is met.The factory default is 1.*DTE_PW_TermChar: 013Nxt 013DTE Password Termination Character. Allows you to change the ASCII character used to indicate the end of a passwordor User ID entered by an originating user. This character can be set to any ASCII value from 1 to 47, 58 to 64, 91 to 96,or 123 to 127.The factory default is 13 (ASCII carriage return).* This configuration option does not appear if the Answer Security Mode configuration option is configured for No AnswerSecurity.