Paradyne 6381-A3 User Manual

Also see for 6381-A3: Quick installation instructions

3. Using the Web Interface3-24 January 2005 6381-A2-GB23-10SNMPUse the SNMP (Simple Network Management Protocol) screen to enable andconfigure the SNMP agent and SNMP trap managers.The SNMP feature generates a trap whenever the IP address of the routerchanges (except through the Troubleshooting Management Link). The trap sentcontains the following: Community (the community name configured for the trap destination, or“public” if no community name was configured) sysObjectID for the router IP address of the agent sending the trap Time stamp (sysUpTime) Serial Number of the router IP address of the router Interface nameTo configure SNMP:Procedure1. From the Home screen, click on Advanced and under Advanced, select SNMP.The SNMP screen appears.2. Enable the SNMP traps, then enter up to five Destination IP Addresses andCommunity names.The Apply button will temporarily save these settings. To make the changepermanent, click on Tools and select System Commands. On the SystemCommands page, click on Save All.Figure 3-20. SNMP