Paradyne BitStorm 2600 IP DSLAM Installation Manual

Also see for BitStorm 2600 IP DSLAM: Installation guide Installation guide

Contents

2. Cabling2600-A2-GN20-50 April 2005 2-5T1 or E1 UplinkModels that support T1 or E1 have eight ports that can be used in any combinationto provide PPP or MLPPP uplinks.ProcedureTo use T1 or E1 uplinks:1. Use the CLI or web interface to configure PPP or MLPPP paths.2. Connect an 8-position modular cable to one of the eight T1 or E1 ports on thefaceplate of the DSLAM. Connect the other end of the cable to the uplinkinterface.3. Connect up to seven other T1 or E1 cables as in Step 2.4. Fix the cable or cables to the rail as required for strain relief.CAUTION:It is possible to create bridging loops by connecting cables improperly relativeto the configuration defined on the SCP card.'+*+((,'- (!./!./ #!%!!!!!!!.!/!!#%!&+-!!%0!%%- &+-!%0!%%-(,'-1&(,&+-*