Paradyne COMSPHERE 3610 Quick Reference Manual

Also see for COMSPHERE 3610: Notice Installation instructions User guide Quick reference guide Quick reference guide

Contents

Paradyne COMSPHERE 3610 Quick Reference Manual Manual pdf 14 page image

12If you are . . . Then return to . . .Selecting another port Change MUX Opts, Step 7.Finished The Edit /Save screen.10. Select SAVE.Network Verification TestingPerform verification testing after any installation. Procedure1. Request a device Identity report from each tributary to ensure that the DSU isaddressed properly (ID from the Status branch).NOTE:The Model 3610 is delivered with its network address set to 254.2. Perform a Digital Test on the DDS circuit to ensure that the network is functioning(DT from the Test branch).Perform a Digital Test on each:— Active port when MUX Funct is set to TDM— Tributary DSU when MUX Funct is set to MCMPNOTE:Acontrol DSU can originate a Digital Test in a point-to-point or multipointnetwork. Use Position in the Diagnostic General configuration option table toset a unit to Cntrl.Atributary DSU can originate a Digital Test in a point-to-point network only,provided the configuration option Respond to Remote Digital Loopback(RespondRDL) is enabled in the control.Front PanelsThe front panel is the user interface to the DSU. There are two types of front panels: Front panel on the Model 3610 DSU. SDCP (shared diagnostic control panel) used with the Model 3611 DSU in aCOMSPHERE 3000 Series Carrier.Front panel operation does not vary with the addition of DSU options (DBM, TDM,MCMP, or SNA Diagnostic Interface). However, menu or selection displays may varybased on installed options. Refer to the User’s Guide for basic front panel, display,keypad, and menu function information.