7Configuration Option TablesIn the tables that follow, FacT (Factory Tributary) defaults are shown in boldface. Ifdifferent from the FacT defaults, FacC (Factory Control) defaults are shown initalics.Key to symbols: Configuration options that do not appear when Full mode is disabled usingMenu from the Configuration branch. ISDN and Switched 56 Digital DBMs ISDN DBM only V.32 Analog DBM only When the Async→Sync configuration option is enabled using the MUX Portnbranch, the following DBM PrtSp settings do not appear: 32, 18.0, 8.4, 4.0,and 2.0 kbps. ISDN and 2-wire Switched 56 DBMs only Not available for Switched 56 DBMs; defaults to 56 kbps. Ports 3–6 are not available for 2-port Flex MUX models. Not available for a DBM-X or a DSU with Primary core set to Yes; the DSU isDisabled 4-wire Switched 56 DBM only Appears when non-Flex MCMP/TDM is installed or 6-port MCMP/TDM Flex isinstalled with firmware version less than 6.33DSU Configuration OptionsDSUConfiguration Options ValueRate(Kbps) Auto, 64CC, 64L, 56, 38.4, 19.2, 9.6, 4.8, 2.4TxClkSource Int, RXC, Ext, DDS, Prt1, Prt2, Prt3, Prt4, Prt5, Prt6Msg Clamp Enab, DisabTxElasStor Enab, DisabRxElasStor Enab, Disab19.2 PowrLvl + 6, 0, –1064KScramblng On, Off64KLatchLpbk On, OffNetIntf AggSw, Forc, DisabNet ITiming Int, NetI, Prt1, Prt2, Prt3, Prt4, Prt5, Prt6V.54 Lpbk Enab, DisabDiagnostic DSUConfiguration Options ValueDiag Type NonD, Disr, Mixed, None2nd Ch(bps) 100, 400, 800, 1200, 1600Disr Type 2500, 2600, 3600s, 3600e, Br56