Safety InstructionsF3610-A2-GB43-50 December 1996CanadaNotice to Users of the Canadian Telephone NetworkThe Canadian Department of Communications has certified that this equipment meets certaintelecommunications network protective, operational, and safety requirements. The Departmentdoes not guarantee that the equipment will operate to the user’s satisfaction.Before installation, verify connectivity of this equipment to the local telecommunicationscompany’s facilities. The equipment must be connected by an acceptable method. In some cases,the telecommunications company’s inside wiring associated with single-line individual servicemay be extended with a certified connector assembly (telephone connection cord). The customershould be aware that compliance with the above conditions may not prevent degradation of servicein some situations.If you experience difficulty with this equipment and require service, refer to the EquipmentWarranty and Support section.Repairs to certified equipment should be made by an authorized Canadian maintenance facility.Any repairs or alterations made by the user to this equipment, or equipment malfunctions, maycause the telecommunications company to ask you to disconnect the equipment.Users should ensure that the electrical ground connections of the power utility, telephone lines andinternal metallic water pipe system, if present, are connected together for protection. Thisprecaution may be particularly important in rural areas.CAUTIONUsers should not attempt to make such connections themselves,but should contact the appropriate electric inspection authority,or an electrician, as appropriate.The load number (LN) is labeled on the equipment. The LN denotes the percentage of the totalload to be connected to a telephone loop used by this equipment. To prevent an overload, the totalof the LNs of all devices attached to the loop may not exceed 100. The LN also specifies theappropriate ringing type (A or B), if applicable. For example, LN = 20A designates a load numberof 20 and an A type ringer.Equipment Warranty and SupportIf you experience trouble with this equipment, please contact your sales or service representative(as appropriate) for repair or warranty information. If the product needs to be returned to thecompany service center for repair, contact them directly for return instructions using one of thefollowing methods:• Via the Internet: Visit the Paradyne World Wide Web site at http://www.paradyne.com• Via Telephone: Call our automated call system to receive current information via fax or tospeak with a company representative.— Within the U.S.A., call 1-800-870-2221— International, call 727-530-2340If the trouble is causing harm to the telephone network, the telephone company may request thatyou remove the equipment from the network until the problem is resolved.