Paradyne COMSPHERE 6800 Series Communications Products Support Configuration Manual

Also see for COMSPHERE 6800 Series: Release note Release note Release note Installation and Enabling/Disabling Instructions Multiplexer Management and Configuration Guide

Paradyne COMSPHERE 6800 Series Communications Products Support Configuration Manual Manual pdf 40 page image

Configuring Devices2-76800-A2-GB20-20 January 1997Configuring DSUsThe DATAPHONE II 2700 Series Data Service Units (DSUs) can be configured to performspecific functions by setting the following device option:device optionsThis option can be configured by executing the following commands:Change Options (cho)Execute this command to configure device options for DATAPHONE II 2700 Series DataService Units (DSUs).Display Options (dso)Execute this command to display the option setting for all DATAPHONE II DSUs fromthe NMS.Refer to the COMSPHERE 6800 Series Network Management System Communications ProductsSupport Command Reference Manual for a complete explanation of these commands.Configuring DDD ModemsThe DATAPHONE II DDD modems can be configured to perform specific functions by setting thefollowing options:device optionsfault-monitoring parametersThese options can be set by executing the following commands:Change Options (cho)The DATAPHONE II DDD modems have device options that are set by hardwareswitches on the modem and by executing this command through the 6800 Series NMS viaa Shared Diagnostic Unit (SDU). If the SDU and modem are installed in a multiplemounting, execute this command to set the transmission mode, modem operation, EIAinterface, private line/disconnect, and answer options for the modems.Call Fault Criteria (cfc)The DDD modems fault-monitoring parameters can be set by executing this commandthrough the 6800 Series NMS via a Shared Diagnostic Unit (SDU). You can execute thiscommand to set the parameters to monitor ring no-answer (NA) and short holding time(HT) faults.Call Fault Read (cfr)Execute this command to display the statistics for the ring no-answer and short holdingtime faults of the DDD modems.