Paradyne HOTWIRE 8610 DSLAM Installation Instructions Manual

Also see for HOTWIRE 8610 DSLAM: Installation guide

Contents

5Hotwire 8610 DSLAM Components99-16311TMTMSTACKPOSITION23 6541ACINPUT123ESDESD48VDC CLASS 2OR LIMITEDPWR SOURCE48VARTNA BB A BDC FUSEST4A, MIN. 48V PWRAALMFANBOUTIN SERIAL ALM INTF MCP/1 2 3MCP/DSLMANAGEMENT 10 BASE T8610MCP8000SYSTEMOKAlrmTestTXRXCollETHERNETSYSTEMOKAlrmTestTXRXCol1234ETHERNETDSL PORTRADSL8546The Hotwire 8610 DSLAM consists of the following components: Hotwire 8610 DSLAM base chassisHotwire 8610 DSLAM is a 3-slot chassis designed to house one MCP card in thefirst slot and up to two DSL cards in the remaining slots. Since the MCP card in the8610 system can provide management connectivity for up to five other 8610DSLAMs, these other systems can use the first slot for a DSL card, thus housingup to three DSL cards. One Management Control Processor (MCP) cardThe Hotwire 8610 DSLAM requires one MCP card mounted in Slot 1 of the base,or first, chassis in a stack. The MCP card is a processor card that administers andprovides diagnostic connectivity to DSL cards in from one to six 8610 DSLAMs. Itacts as a mid-level manager and works in conjunction with an SNMP networkmanagement system, such as HP OpenView, via its LAN port. It gathersoperational status for each of the DSL cards and responds to the SNMP requests.It also supports a serial port for local terminal access. At least one Digital Subscriber Line (DSL) cardThe 8610 DSLAM requires at least one DSL card. Each DSL card contains anumber of DSL ports (depending on model), Ethernet interface circuitry, and aprocessor. The processor controls the modems and forwards the packet traffic toand from the Ethernet and DSL interfaces.NOTE:You must order the MCP and DSL cards separately. They are not provided with thechassis.