Paradyne HotWire 7924 User Manual

Also see for HotWire 7924: User guide User guide User guide

Contents

Paradyne HotWire 7924 User Manual Manual pdf 24 page image

Customizing DSX-1-Compatible Units4-6 7924-A2-GB20-30October 1997Displaying Line Build-Out DefinitionsEnter 7 at the Config prompt to display the switchpack and board settings for linebuild-out. Use this information to change the line build-out parameter manually.(Switchpack definitions are also listed in Appendix C,Switchpacks and Jumpers.)Config→ 7***** SWITCHPACK SETTINGS FOR LINE BUILD OUT *******Switchpack Settings–––––––––––––––––––––––––––––––––––Position #4 – Bit 0 OFF=0, ON=1Position #5 – Bit 1 OFF=0, ON=1Position #6 – Bit 2 OFF=0, ON=1************ Switchpack Definitions ************Bit 2 Bit 1 Bit 0 Application–––––––––––––––––––––––––––––––––––––––––––––––0 0 0 0 to 133 feet – 0dB0 0 1 133 to 266 feet0 1 0 266 to 399 feet0 1 1 399 to 533 feet1 0 0 533 to 655 feet1 0 1 -7.5 dB1 1 0 -15 dB1 1 1 -22.5 dBConfig→For example, to change the line build-out to 399 to 533 feet, while in SwitchpackMode, set position 6 OFF and positions 4 and 5 ON.NOTE:The switch combinations for –7.5, –15, and –22.5 dB line build-out are not foruse with this product. Use of these settings will cause a weak signal anddegrade performance.