Paradyne Hotwire 5446 Installation Instructions Manual

Also see for Hotwire 5446: Installation instructions Notice Installation instructions Installation instructions

Contents

Paradyne Hotwire 5446 Installation Instructions Manual Manual pdf 8 page image

8Installing the Hotwire 5446 RTUPlace the Hotwire 5446 RTU on a flat surface with clearance for the rear connectors. Procedure1. Use the RJ11 6-pin cable for the DSL connection. Insert one end of the cable intothe jack labeled DSL. Insert the other end into the wall jack labeled DSL.97-15300-01DSLJackPOWERETHERNETDSLHotwire RTUIf the Hotwire 5446 RTU is installed on the same line as POTS, a Hotwire 5038Distributed POTS Splitter can be used as a filter. One 5038 Distributed POTSsplitter is installed as a filter for each telephone, as shown below. To install theHotwire 5038 Distributed POTS splitter, refer toHotwire 5038 Distributed POTSSplitter Customer Premises Installation Instructions.98-15813DistributedPOTS SplitterLine fromRJ11 Wall JackPHONELINE DSLPHONELINE DSLPHONELINE DSLLine fromRJ11 Wall JackDistributedPOTS SplitterDistributedPOTS SplitterCustomerPremises (CP)HotwireRTU