18774-A2-GZ40-30 February 2001Hotwire 8774 TDM SDSL Termination Unitwith DSX-1 InterfaceInstallation InstructionsDocument Number 8774-A2-GZ40-30February 2001Product Documentation OnlineComplete documentation for this product is available at www.paradyne.com.Select Library → Technical Manuals → Hotwire DSL & MVL Systems.Select the following document:8774-A2-GB20Hotwire 8774 TDM SDSL Termination Unit, with DSX-1 Interface, User’sGuideTo order a paper copy of a Paradyne document: Within the U.S.A., call 1-800-PARADYNE (1-800-727-2396) Outside the U.S.A., call 1-727-530-8623Hotwire 8774 TDM SDSL Termination UnitThe Hotwire 8774 Termination Unit is a circuit card assembly that contains fourTime Division Multiplexer Symmetric Digital Subscriber Line (TDM SDSL) portsand a DSX-1 interface. When the termination unit is used in a Hotwire 8600 or8800 Series Digital Subscriber Line Access Multiplexer (DSLAM) chassis, ittransports up to 1544 kbps signals over traditional twisted-pair telephone wiring.! HANDLING PRECAUTIONS FORSTATIC-SENSITIVE DEVICESThis product is designed to protect sensitive components from damagedue to electrostatic discharge (ESD) during normal operation. Whenperforming installation procedures, however, take proper static controlprecautions to prevent damage to equipment. If you are not sure of theproper static control precautions, contact your nearest sales or servicerepresentative.496-15104

installation instructions

planning the installation

front panel leds

entering identity information

important safety instructions

document feedback

Paradyne Hotwire 8774 Installation Instructions Manual

Hotwire 8774

about this guide

T TDM SDSL Overview

T Hotwire 8774 Termination Unit Features

network configuration

T User Interface Types

Telnet Session Options

menu hierarchy

screen work areas

Keyboard Keys

Switching Between Screen Areas

ending an ati session

Current and Default Factory Configurations

current and default factory configurations

General SNMP Management Options

saving configuration changes

downloading firmware

disabling autorate

restoring access to the user interface

T What to Monitor

T Viewing System and Test Status

Health and Status Messages

Self-Test Results Messages

T Performance Statistics

Viewing Network Performance Statistics

Viewing Current Network Performance

Viewing DSX-1 Performance Statistics

viewing led status

T Front Panel LEDs

accessing the test menu

running network tests

Line Loopback

Repeater Loopback

DTE Loopback

Remote Send Line Loopback

Send and Monitor 511

T Device Tests

ending an active test

T Telco-Initiated Tests

Telco-Initiated Remote Line Loopback

configuring snmp traps

device messages

troubleshooting

ati access levels

Assigning SNMP Community Names and Access Types

Configurations Not Running IP Conservative Software

T IP Addressing Example

system options

management and communication menu

general snmp management options

snmp nms security options

snmp trap options

warmStart

linkUp and linkDown

snmp traps

technical specifications

Configuration Options

Health and Status

Management Information Base (MIB) Support

Screen Function Keys

Switching Between Screen Work Areas

Self-Test Results

Test Status

Send Remote Line Loopback

Lamp Test

H Configuring SNMP Traps

SNMP Traps Options

Limiting SNMP Access through the IP Addresses of the Managers

H SNMP Traps

SNMP NMS Security Options

H Hotwire 8600 DSLAM Telco 50-pin Connector Pinouts for DSL Loops