Parker 404 Product Manual

Parker 404 Product Manual Manual pdf 25 page image

404/406XR Series Product Manual Chapter 4 - Base Mounting Procedures25 Parker Hannifin Corporation1140 Sandy Hill RoadIrwin, PA 15642www.parkermotion.comToe clamp mountingTools Required: Allen Key M5 The 404/406XR series can be mounted utilizing optional toe clamps. For 50mm travel positioners use (4) Toe Clamps. Add (2) clamps for each additional 150mm travel. Mount Toe Clamps onto work surface using counter-bored holes provided. M6 (4) Low Head Cap Screw(404XR) or Socket Head Cap Screw (406XR) can be used to mount to customer mounting surface.Riser BlocksTools Required: Allen Key M5, M2.5, M2Most of the motors used with the 404/406XR series have a taller profile than the positioner. Thus theunit cannot be mounted with the motor and table in the same plane. Riser blocks can be provided tospace the table above a mounting surface. Locate sufficient amount of Riser Blocks for the required length of travel. Lay out Riser Blocks such that the entire length of the positioner is supported. Access interior of the positioner. See Internal Access Procedure Chapter 6. Mount Riser Blocks to the positioner using M6 X 20 screws provided. Mount positioner to the work surface using counter-bored holes in the riser blocks. Reassemble positioner.Ballscrew endcover plateTop cover screws, (4) placesTop CoverSlide cover away frommotorwww.comoso.com