Parker Matrx MDM Installation Manual

Also see for Matrx Digital MDM: Operation manual Cabinet Mount Installation Instructions Operation manual

Contents

Parker Matrx MDM Installation Manual Manual pdf 14 page image

12NOTEThis cylinder mounting procedure will be typical for either nitrous oxide or oxygen cylinders.CAUTION Do not attempt to assemble nitrous oxide cylinder to oxygen yoke or oxygen cylinder tonitrous oxide yoke. Do not remove pins from yoke assembly. Use “E” or “D” size cylinders only.1. Rotate the tee handle screw clamp in a counter-clockwise direction until the point of the screw isflush with the inside edge of the yoke bar.2. Remove the cylinder seal from the captive strap on the cylinder. Dispose of the captive strap.3. Place the cylinder seal on the cylinder seat such that gas nipple goes through the hole in thecenter of the cylinder seal. See Figure 23.4. Locate the “E” cylinder directly underneath the cylinder with the cylinder shut-off valve locatedtowards the cylinder yoke and such that the face of the cylinder valve will face the face of theyoke. See Figure 23 and 24.5. Lift the cylinder shut-off valve through the yoke block and align the yoke pins with the pin holesand the gas nipple with the cylinder port.6. Move the cylinder towards the face of the yoke so that the pins and gas nipple engage with the pinholes and cylinder port.7. Rotate the Tee handle screw clamp clockwise until the point on the screw engages thecountersink on cylinder shut-off valve post.8. Hand tighten (do not use tools) the tee handle screw clamp until it is very tight.Assembly of “E” Size Cylinders to Portable Units with Cylinder Mounts (cont.)B. CYLINDER MOUNTING (cont.)