Parmco HO-4-77NF-CER-T Installation And Operating Instructions Manual

Also see for HO-4-77NF-CER-T: Installation and operating instructions

Contents

Parmco HO-4-77NF-CER-T Installation And Operating Instructions Manual Manual pdf 7 page image

71. The ceramic hob must only be installed by a qualified technician.2. The hob shall not be mounted to cooling equipment, dishwashers and rotary dryers etc.3. To avoid any damage, the benchtop and adhesive must be made of suitable heat resistant properties4. A steam cleaner is not to be used.5. If this hob is to be installed above a draw or cupboard a protective board able to withstand 120°C must beinstalled underneath with minimum clearance of 25mm. The 5mm air exit gap in the front of the cabinetry(refer fig.2) is required.4 Power connectionThe socket shall be connected according to the relevant standard or connected to a single-pole cut-out. 30Aminimum supply. The method of connection is shown in Figure (3):The installer must ensure that the correct electrical connection has been made and that it complies with ALLrelevant electrical compliance’s and New Zealand standards.If the cable is damaged and needs to be replaced, the operation must be only carried out the by an authorisedperson. If the appliance is being connected directly to the mains an omnipolar circuit breaker must be installedwith a minimum opening of 3mm between contacts.The installer must ensure that the correct electrical connection has been made and that it complies with NewZealand standards. The cable must not be bent or compressed. The cable must be checked regularly andreplaced by authorised technicians only.WIRING INFORMATIONCAUTIONS