Parmco HX-3-6W-3GW Installation And Operating Instructions Manual

Contents

Parmco HX-3-6W-3GW Installation And Operating Instructions Manual Manual pdf 9 page image

Remove the knob "M" which is simply inserted onto, tap stem.I Insert a small screwdriver "D" into the top shaft "C" andturn the bypass screw left or right until flame of the burner is conveniently regulated to the low position.Make sure that when turning quickly from "Full on" position to reduced rate position that the burner does not extinguish.6. USER INSTRUCTIONS1.To light the hotplate push In the appropriate control knob and turn anti-clockwise to the large2.Keep the knob depressed until the burner lights.3.Turn the tap to the required setting.flame symbol (fig. 8).BURNERS NORMALRATEINJECTORDIAMETERDESCRIPTIONGAS1/100 mm1234SEMIRAPIDRAPID6811114590AUXILIAR Y 52873.63.66.36.313.713.710.810.8103162TRIPLEFLAMEMJ/hInjector replacementnatural gasnatural gasnatural gasUniversal - LPGUniversal - LPGUniversal - LPGnatural gasUniversal - LPGThe final gas connection shall be made using a flexible hose or annealed copper tubing of sufficient length to permit theinsertion and removal of the appliance. For gas appliances connected using a flexible hose, install with a hose assembly thatcomplies with AS/NZ 1869 (Australian approved), 10mm ID class B or D, and in accordance with AS 5601. This hose must notexceed 1.2m in length. $* $ installed underneath or next to the cooktop. The hose should be positioned so that it does not interfere with drawers or othermoving parts, and so that it is not subjected to abrasion, kinking, or permanent deformation. The hose should be able to beinspected along its entire length. Unions compatible with the fittings must be used and all connections must be tested.` ; point. The length of the chain or wire is not to exceed 80% of the length of the hose assembly.+ |* * $ ; appliance, so that the gas supply to the appliance can be shut off in the event of an emergency or for servicing without having toremove the appliance.& $ appliance recess and must be readily accessible without having to remove the appliance.COMMISSIONING PROCESSThe below process must be performed on the gas cooktop by the authorised plumber/gasfitter before leaving:Z | @ Q Q @ $ $ FINAL INSTALLATION CHECKSAfter commissioning and before leaving, the installer must check and ensure that:` \ $ * $ ] $ * # $ * "+_"^># * # * \$adjustments involving any disconnection and reconnection), follow the below leak test procedure. Never use a naked flame to %In a small container, mix up a solution of water and detergent or soap. Make sure that the gas supply is turned on and all gascontrol valves on the appliance are off. Using a brush or spray bottle, apply the solution to the gas line and each joint in the gasline, including any flexible hosing and regulator. Bubbling of the solution will indicate that there is a leak present.Retighten or reseal any joints that are leaking. If the leak persists, contact our after sales support centre for assistance.6

/ 10

Related manuals for Parmco HX-2-6S-4G