Paslode CF325Li Operating Manual

Paslode CF325Li Operating Manual Manual pdf 13 page image

13FastenersThe Paslode Cordless Framing Nailer drives PaslodeRounDrive® nails, which have been collated into strips. Theuse of nails that do not meet Paslode standards could causetool damage and void your warranty. Paslode nail sizes andtypes are illustrated in the Fasteners and Applicationssection.Loading FastenersSTEP 1: To load, pull the follower handle back to the rearlock position (button will pop up).STEP 2: Insert a strip of nails and release follower bypushing on button.There is a reload indicator on follower and tool. A full stripcan be loaded in this area as shown above.Preparing the Paslode Cordless Framing Nailer for UsePaslode Cordless Framing Nailer andOutdoor WeatherUse the Cordless Framing Nailer outdoors, in clear weather,when the nailer, fuel cartridge, and battery are between20°F (-7°C) and 120°F (49°C.HOT WEATHER OPERATIONThe Cordless Framing Nailer requires cooling of the motorassembly to operate properly. The fan normally providesthe necessary air flow to permit continuous operation.Whenever the Cordless Framing Nailer is idle for extendedperiods, keep the fuel and tool out of direct sunlight and insurroundings where temperatures will not exceed 120°F(49°C). After extended periods of continuous use, it may benecessary to cool the motor by setting tool aside for 10-15minutes or until the tool operates normally. An overheatedtool may not drive nails completely or may operate erratically.COLD WEATHER OPERATIONFuel at cold temperatures lose the required propellant force.Bring the tool, battery, and fuel cartridge above minimumoperating temperature without direct exposure to flame, andcheck the battery.CAUTIONThe Cordless Framing Nailer should not be used in therain or where excessive moisture is present. The useof the Paslode Cordless Technology under theseconditions may result in damage to tool componentsand cause tool to malfunction.The purpose of this feature is to prevent needlessblank cycling,which could waste fuel and damagetool components. Five (5) nails will be left in themagazine when the follower reaches the lockoutarea. The indicator arrow shows that you can reload.It does not indicate that the Cordless Framing Naileris empty. Because of a lockout feature in theCordless Framing Nailer it will not operate when thenail supply in the tool is less than six (6) nails.Lockout Feature