Paslode IM250A Li Operating Manual

Also see for TrimMaster IM250A-Li: Cleaning procedure Operating manual Quick reference guide

Contents

Paslode IM250A Li Operating Manual Manual pdf 7 page image

WarningCHEMICAL/EXPLOSIONHAZARDRead ALL instructions be-fore charging or using bat-tery. Failure to follow ALLinstructions may result infire, severe burns, or re-lease of toxic materials.Battery and Charging SystemCharging Instructions1.2. Remove the battery from tool or case and insert ter-minals down into charger. The red light will come onindicating that the battery is charging and the greenlight will go out.3. After charging is complete, the red light will go outand the green light will come on, indicating that thebattery is fully charged. The charger will keep thebattery at full charge until it is removed.4. Unplug the charger from the 120V AC outlet.CHARGING TIMES:First charge (new battery) 1 hourDischarged Battery 5 minutes to 1 hourCHARGING DON'TS:1. Do not charge battery outdoors or in temperaturesbelow 40°F (5°C).2. Do not allow metal objects to come in contact withbattery terminals.3. Do not puncture or attempt to open battery case orcells.4. Do not store battery where it will be subjected totemperatures above 120°F (49°C).5. Do not incinerate battery.6. Do not use a defective battery charger, one thatover-heats and/or smokes when plugged in.7. Do not immerse the battery or charger in water.Charging System Accessories:Battery Charger - Part No. 902672NoteBattery and Charging SystemImportant Charging NotesRemove the charger unit from the tool case and plugit into a 120V AC outlet. Set the charger base on astable surface. A green light will come on to indicatethe power is on and the charger circuit is ready.If battery is completely discharged, the red light andthe green light may alternate back and forth for up to20 minutes. This safety feature slowly recharges thebattery until it is ready to accept the full chargingcurrent. If the red and green lights continue to alter-nate after 20 minutes, replace the battery.The Paslode Cordless 16 Gauge Angled Lithium-ionFinish Nailer comes with a rechargeable battery andits own charging system. This charging system isthe only one that will work with the Paslodelithium-ion batteries. The first step in preparing anew tool for operation is to fully charge the battery.New batteries are shipped partially dischargedand must be charged prior to first use. Batterieswill take 5 minutes to 1 hour (time will be dependanton the amount of discharge of the battery) torecharge.6ft. CordBatteryChargerTHE PASLODE BATTERY CHARGING SYSTEM