175.0 INSTALLATIONOnce the Model 2701/I is properly configured, it is ready to connect tothe G.703/G.704 interface, to the Ethernet port, and to the power source.This section describes how to make these connections.5.1 CONNECTING TO THE G.703 NETWORKThe Power, G.703/G.704 and Ethernet Line connections are located onthe rear panel of the Model 2701/I. Figure 5 shows the location of eachof these ports.Figure 5. Model 2701/I Rear PanelConnecting Dual Coaxial Cable (75 ohm) to the G.703 NetworkThe Model 2701/I is equipped with dual female BNCs (TX and RX) forconnection to a 75 ohm dual coax G.703 network interface. If yourG.703/G.704 network terminates via dual coaxial cable, use the diagrambelow to make the proper connections. See Figure 6 below.Figure 6. Rear Panel, Showing Location of Connectors.Note The outer conductor of the coax cables are isolated from systemearth ground.The Interconnecting cables shall be acceptable forexternal use and shall be rated for the proper applica-tion with respect to voltage, current, anticipated tem-perature, flammability, and mechanical serviceability.WARNING