Patton electronics 2710RC Series User Manual

Contents

1 2TABLE OF CONTENTSSection Page1.0 Warranty Information .............................................................21.1 Warranty Statement1.2 Radio and TV Interference1.3 Equipment Attachment Limitations1.4 Patton Contact Information1.5 FCC Part 68 Compliance Statement2.0 General Information...............................................................52.1 Features2.2 General Product Description3.0 Configuration .........................................................................63.1 DIP Switch Configuration3.2 Configuring the Rear Interface Card3.3 Software Configuration4.0 Installation ..........................................................................354.1 The Model 1001R14 Rack Chassis4.2 Installing the Interface Driver Board4.3 Installing the 2710RC Into the Rack Chassis4.4 Connecting to a DTE Device4.5 Connecting to a DCE Device4.6 Connecting the T1 Interface5.0 Operation .............................................................................395.1 LED Descriptions5.2 Loop (V.54 & Telco) Diagnostics5.3 Bit Error Rate (V.52) DiagnosticsAppendix A - Specifications ........................................................44Appendix B - Cable Recommendations......................................45Appendix C - Factory Replacement Parts and Accessories ......46Appendix D - T1 Interface Pin Assignments ..............................47Appendix E - DTE Interface Pin Assignments ............................481.0 WARRANTY INFORMATIONThank you for your purchase of this Patton Electronics product.This product has been thoroughly inspected and tested and is warrant-ed for One Year parts and labor. If any questions or problems ariseduring installation or use of this product, please do not hesitate to con-tact Patton Electronics Technical Support at (301) 975-1007.1.1 WARRANTY STATEMENTPatton Electronics warrants all Model 2710RC Series componentsto be free from defects, and will—at our option—repair or replace theproduct should it fail within one year from the first date of shipment. Thiswarranty is limited to defects in workmanship or materials, and does notcover customer damage, abuse, or unauthorized modification. This prod-uct contains no serviceable parts; therefore you should not attempt tomodify the unit in any way. If this product fails or does not perform aswarranted, your sole recourse shall be repair or replacement asdescribed above. Under no condition shall Patton Electronics be liablefor any damages incurred by the use of this product. These damagesinclude, but are not limited to, the following: lost profits, lost savings andincidental or consequential damages arising from the use of or inability touse this product. Patton Electronics specifically disclaims all other war-ranties, expressed or implied, and the installation or use of this productshall be deemed an acceptance of these terms. In the event that youdetect intermittent or continuous product malfunction due to nearby highpower transmitting radio frequency equipment, use only data cables withan external outer shield bonded to a metal or metalized connector.1.2 RADIO AND TV INTERFERENCEThe NetLink-T1™ Model 2710RC Series generates and uses radiofrequency energy, and if not installed and used properly—that is, instrict accordance with the manufacturer's instructions—may causeinterference to radio and television reception. The Model 2710RCSeries has been tested and found to comply with the limits for a ClassA computing device in accordance with the specifications in Subpart Bof Part 15 of FCC rules, which are designed to provide reasonable pro-tection from such interference in a commercial installation. However,there is no guarantee that interference will not occur in a particularinstallation. If the Model 2710RC Series causes interference to radio ortelevision reception, which can be determined by disconnecting thecables, try to correct the interference by one or more of the followingmeasures: moving the computing equipment away from the receiver,re-orienting the receiving antenna, and/or plugging the receiving equip-ment into a different AC outlet (such that the computing equipment andreceiver are on different branches).WARNING! This device is not intended to be con-nected to the public telephone network in Europe.