Patton electronics IPLink 2603 Quick Start Manual

Also see for OnSite 2620: Specification sheet Quick start guide

Contents

IPLink 2603 & 2620 Quick Start Guide 31.3 Models with internal DC power supply1. Strip insulation 1/4-inch from the electrical wires that will connect the DC power source to the IPLink.2. Connect the ground terminal from the power source to the ground terminal on the IPLink.3. Connect the negative (-) terminal from the power source with to the negative (-) terminal on the IPLink.4. Connect the positive (+) terminal from the power source with to the positive (+) terminal on the IPLink.1.4 Power-up indicationThePower LED blinks as the IPLink is powering up. When thePower LED stops blinking and remains lit, theIPLink is ready for you to configure.2.0 Configure the IP addressThe IPLink is shipped with a factory-configured IP address assigned to theEthernet LAN port (green outline). Theaddress is192.168.200.10/24. In most cases, you must change the address to be on the same subnet as yourPC, as described in the procedures below. If you are not sure which IP address to use for your installation, contactyour network administrator.2.1 Connecting a PC and logging in1. Using the included combination RS232/Ethernet cable and DB9-RJ45 adapter, connect a PC’s serial portto the IPLink’sConsole port (see figure 1).Figure 1. Connecting IPLink to the PC’s serial port2. Start a HyperTerminal session on the PC using the settings:9600 bps, 8 data bits, 1 stop bit, no parity, no flow control3. Log in to the IPLink using the factory-default login and password:Login:superuserPassword: superuserLogin successfulLinkFrameTDRDLink100MTxRxWANEthernetPowerConsoleipLink GatewayHigh Speed WAN Access RouterModel 2603Connect to Console portSerial portPC withterminal emulator