Patton electronics SIPxNano Quick Start Manual

Also see for SIPxNano: Getting started guide

Contents

Patton electronics SIPxNano Quick Start Manual Manual pdf 3 page image

SIPxNano Quick Start Guide 34.0 Running the reset scriptWhen you turn on the SIPxNano for the first time, you will need to run and configure a reset script before youcan access the webpage interface.When you boot the system, a CLI prompt will appear asking for a login and password:• login: root• password: superuser• [root@SIPxNano ~]# will appear. To run the reset script, type:/recovery/linux/sipx_reset_cd .Note Do not press “I” for Interactive Setup while running the reset script. Allow the reset script to run withoutinterruption.After running the reset script, you will have the option to change the default settings such as the hostname, IPaddress, netmask, gateway, nameserver, password, and timezone. If you would like to keep the default settings,press at each prompt. Type ‘yes’, then press . The system will reboot.Note If you make a mistake while running the reset script or changing the default settings, type ‘CTRL+C’ tointerrupt the reset script and start over.After the system reboots for the second time, enter the login and password you set (or the default settings, if youdid not make any changes).5.0 Accessing the systemEnter the IP address of the SIPxNano (in this example, 10.10.200.1) into a web browser on a separate PC. Besure that the PC is on the same subnet as the SIPxNano.To log into the SIPxNano:1. After typing the IP address into a web browser, a welcome screen will appear.Click on the ‘Configuration’ link.2. Log into the webpage interface. The default login and password are:User ID: superadminPIN: patton3. The SIPxNano homepage will appear.4. From the main page, on the main navigation menu at the top, you can access the configuration pages forsetting up Users, Devices, Features, System, or Diagnostics.