Philips 19B1CB/27 User Manual

Also see for 19B1: User manual

Contents

• Safety andTroubleshooting• FAQs• Common Problems• Imaging Problems• Regulatory InformationTroubleshootingThis page deals with problems that can be corrected by a user. If the problem still persists after you have tried thesesolutions, contact Philips customer service representative.Common ProblemsHaving this problem Check these itemsNo Picture(Power LED not lit)Make sure the power cord is plugged into the power outletand into the back of the monitor.First, ensure that the power button on the front of the monitoris in the OFF position, then press it to the ON position.No Picture(Power LED is white blinking)Make sure the computer is turned on.Make sure the signal cable is properly connected to yourcomputer.make sure the monitor cable has no bent pins on the connectside. If yes, repair or replace the cable.The Energy Saving feature may be activatedScreen saysMake sure the monitor cable is properly connected to yourcomputer. (Also refer to the Quick Set-Up Guide).Check to see if the monitor cable has bent pins.Make sure the computer is turned on.AUTO button doesn't function in VGAmodeThe auto function is applicable only in VGA-Analog mode. Ifthe result is not satisfactory, you can do manual adjustmentsvia the OSD menu. Note that the Auto Function is notapplicable in DVI-Digital mode as it is not necessary.Imaging ProblemsImage is not centeredPress the Auto button.Adjust the image position using the Phase/Clock of Setup inOSD Main Controls.