Philips 4000 Series User Manual

Also see for 4000 series: Quick start guide User manual Quick start guide Service manual Quick start guide

3 Get startedCharge the batteryNote Before you use your headset for the firsttime, charge the battery for 5 hours foroptimum battery capacity and lifetime. Use only the original USB charging cableto avoid any damage. Finish your call before charging theheadphones, as connecting theheadphones off. You can’t operate the headphonesnormally during charging.Connect the supplied USB chargingcable to:• the USB-C charging slot onthe headphones and;• the charger/USB port of acomputer.LED turns white duringcharging and turns off when theheadphones is fully chargedearliest paired device is replaced by thenew one.1 Make sure that the heaphones arefully charged.2 Press and hold for 2 seconds toturn the headphones on.3 Make sure that the mobile phone isturned on and its Bluetooth featureis activated.4 Pair the headphones with themobile phone. For detailedinformation. refer to the usermanual of your mobile phone.The following example shows youhow to pair the headphones with yourmobile phone.1 Activate the Bluetooth feature ofyour mobile phone, select PhilipsTAK4206.2 Enter the headset password”0000”(4 zeros) if prompted. For thosemobile phones featuring Bluetooth3.0 or higher, no need to enter apassword.Pair the headphones withyour mobile phoneTip Normally,a full charge takes 2 hours.Before you use the headphones withyour mobile phone for the first time,pair it with a mobile phone. A successfulpairing establishes a unique encryptedlink between the headphones andmobile phone. The headphones storethe last 4 devices in the memory. if youtry to pair more than 4 devices, thePhilips TAK42064 EN