Important safety instructionsRead these instructions.Keep these instructions.Heed all warnings.Follow all instructions.Do not use this apparatus near water.Clean only with dry cloth.Do not block any ventilation openings. Install inaccordance with the manufacturer’s instructions.Do not install near any heat sources such asradiators, heat registers, stoves, or other apparatus(including amplifiers) that produce heat.Do not defeat the safety purpose of the polarizedor grounding-type plug. A polarized plug has twoblades with one wider than the other. A groundingtype plug has two blades and a third groundingprong. The wide blade or the third prong areprovided for your safety. If the provided plug doesnot fit into your outlet, consult an electrician forreplacement of the obsolete outlet.Protect the power cord from being walked on orpinched particularly at plugs, conveniencereceptacles, and the point where they exit fromthe apparatus.Only use attachments / accessories specified bythe manufacturer.Use only with the cart, stand,tripod, bracket, or table specifiedby the manufacturer, or sold withthe apparatus. When a cart isused, use caution when movingthe cart / apparatus combinationto avoid injury from tip-over.1.2.3.4.5.6.7.8.9.10.1 1.12.Unplug this apparatus during lightning storms orwhen unused for long periods of time.Refer all servicing to qualified service personnel.Servicing is required when the apparatus has beendamaged in any way, such as power-supply cordor plug is damaged, liquid has been spilled orobjects have fallen into the apparatus, theapparatus has been exposed to rain or moisture,does not operate normally, or has been dropped.13.14.Note to the CATV system installer:This reminder is provided to call the CATV systeminstaller’s attention to Article 820-40 of the NEC thatprovides guidelines for proper grounding and, inparticular, specifies that the cable ground shall beconnected to the grounding system of the building,as close to the point of cable entry as practical.Example of antenna grounding as per NEC -National Electric CodeANTENNA LEAD IN WIREGROUND CLAMPANTENNA DISCHARGE UNIT(NEC SECTION 810-20)ELECTRIC SERVICE EQUIPMENTGROUNDING CONDUCTORS(NEC SECTION 810-21)POWER SERVICE GROUNDINGELECTRODE SYSTEM (NEC ART 250,PART H)GROUND CLAMPSWall mount bracket kitBrand Model # Screw dimension65PFL592255PFL592250PFL5922SANUS F80b M6 x 1.378” (35mm)43PFL5922 SANUS 25BB M4 x 1.378” (35mm)• Your TV meets the VESA standard for wall mounting. Consult with yourlocal dealer for a wall mount bracket which is compatible with your TVmodel.• The recommended wall mount bracket kit (sold separately) allows themounting of the TV on the wall.• For detailed information on installing the wall mount, refer to the wallmount Instruction book.• Funai Corporation is not responsible for any damage to the productor injury to yourself or others if you elect to install the TV wall mountbracket or mount the TV onto the bracket on your own.• The wall mount bracket must be installed by experts.Funai Corporation is not liable for these types of accidents or injuriesnoted below.• Install the wall mount bracket on a sturdy vertical wall.• If installed onto a ceiling or slanted wall, the TV and wall mount bracketmay fall which could result in a severe injury.• Do not use screws that are longer or shorter than their specified length.If screws too long are used this may cause mechanical or electricaldamage inside the TV set. If screws too short are used this may causethe TV set to fall.• Do not fasten the screws by excessive force. This may damage theproduct or cause the product to fall, leading to an injury.• For safety reasons use 2 people to mount the TV onto a wall mountingbracket.• Do not mount the TV onto the wall mounting bracket while your TV isplugged in or turned on. It may result in an electrical shock injury.When installing the unit on the wall, allow this much space.Top : 1 1.8 inches (30cm)Left and right side : 5.9 inches (15cm)Bottom : 3.9 inches (10cm)4 .English