Philips 55PP9401 Quick Use And Setup Manual

Also see for 55PP9401: Quick use and setup guide Directions for use Directions for use Specifications Service manual

POWER INPUTEXIT SELECTPUSHPOWER INPUTEXIT SELECTVOL+VOL-CH-CH+VOL+VOL-CH-CH+412 3MENUMENU3PERFORMING BASIC TV OPERATIONSTELEVISIONPOWER Button—Press to turn the TV on or off. With theTV off, press and hold this button for five seconds to see anauto-demonstration of the on-screen displays with HELP text.LIGHT Button—Press to back-light the remote control.PIP Buttons—Press to perform Picture-in-Picture featurefunctions. See the section on Picture-in-Picture in theDirections for Use manual for details.OK Button—Press to make selections in the on-screen menu.CURSOR Buttons—Press LEFT, RIGHT, UP, or DOWN tomove through, select, and adjust on-screen menu options.MENU/SELECT Button—Press to access the TV’s on-screen menu.CH(annel) +, – Buttons—Press to cycle through all storedchannels that have been placed in TV memory after the “AutoProgramming” function of the TV has been completed.MUTE Button—Press to reduce the sound to one-half thenormal volume (Soft Mute) (good to use when answering thetelephone). Press the MUTE button again to turn the sound offcompletely. Press the button once more to restore the sound, orpress the VOL(ume) + button.NUMBER Buttons—Press to directly access any numberedchannel.SURF Button—Press to access the Favorite Channel screen.Favorite Channel simplifies surfing (going from channel tochannel). It allows you to store up to 36 favorite stations in theSurf™ memory. Favorite Channel has 6 categories with 6channels per category. Add or delete channels from the on-screen listVCR Buttons—Press the VCR buttons to activate certainVCR commands when the remote is in the VCR mode. Thebuttons are for PLAY, STOP, REWIND, FAST FORWARD,PAUSE, RECORD, AND TIMER features.AV1, AV2, AV3, AV4 Buttons—Press to access the fouraudio/video input options on the TV’s Rear Panel.✔ Your TV willappear to be turnedoff if no video inputis present whenA/V:1, A/V: 2,FRNT, A/V: 3, orA/V: 4 are selected.Check the PowerLight to make surethe TV is turned offwhen not in use.✔ Your remotedoes not have anINPUT button. Usethe SOURCE buttonto choose amongsignal sources. Youcan also use theAV 1, AV 2, AV 3,and AV 4 buttons toaccess signalsources.CHECK IT OUTREMOTEBattery Usage CAUTION—To pre-vent battery leakage which mayresult in bodily injury or damage tothe unit:• Install ALL batteries correctly, + and– as marked on the unit.• Do not mix batteries: (OLD and NEWor CARBON and ALKALINE, etc.)• Remove batteries when the unit isnot used for a long time.REMOTE BATTERIES Remove the batterycompartment lid on the backof the remote.Place the batteries (2-AA)in the remote. Be sure the (+)and (-) ends of the batteriesline up correctly (inside of caseis marked).Reattach the batterylid.Press the CH(annel) selec-tor buttons until the number ofthe channel you desire appearsin the right corner of the TVscreen.Press the POWERbutton to turn the TV on.After having connecteda broadcast signal source tothe TV, press the INPUT/EXITbutton to select a source. Thesource options are Tuner A,Tuner B, A/V: 1, A/V: 2, Front,A/V: 3, and A/V: 4. For thisexample, choose the source towhich you connected thebroadcast signal (Tuner A orTuner B).21 354 687 90HELP FORMAT LIGHTTVSOURCEDVDSWAP PIP CH– +SOURCE FREEZEPIP POSITION PIP ON/OFFSTATUS/EXITVOL CHSURFA/CHQTRINTELLISENSEMENU/SELECTVCR ACCTUNER A TUNER B FRONTAV1 AV2 AV3 AV4Remote Control Sensor—pointyour remote at this area whenselecting channels, adjustingvolume, and sending othercommands with the remote.ImageMax™ Sensor—this willmake automatic picture adjust-ments based on the amount oflight in the room to give thebest picture.Press the VOL(ume) levelbuttons to attain your desiredsound level. The volume levelwill be displayed on the TVscreen.In this section, learn howto use the TV buttons forbasic operation of the TV.(See page 4 for information onhow to adjust or set TV con-trols through the on-screenmenu using the buttons on thefront of the TV, if you don’twant to use the remote.)Front Panel Jacks (“FRNT” inputs)—Use theseaudio/video jacks for a quick hookup from acamcorder or VCR to instantly view yourfavorite show or new recording. Press theINPUT/EXIT button on the TV until “FRNT”appears in the top right corner of the TV screen.If you have mono sound, insert the audio cableinto the left audio jack.Offering direct access to the on-screen menu, this remotecontrols all features and functions of your TV. It also con-trols virtually all infrared VCRs, laserdisc/DVD players,and satellite receivers, as well as on/off and channelup/down on most cable converter/decoders (see pages31–36 of the Directions for Use manual for setup informa-tion).SOURCE Button—Press to choose from among the TV’ssignal sources: Tuner A, Tuner B, A/V: 1, A/V: 2, FRNT(Front), A/V: 3, or A/V: 4.Mode Buttons—This remote can be set up to operate aVCR, DVD, laserdisc, cable box, or satellite receiver. PressTV to use the remote with the TV, DVD for DVD andlaserdisc, VCR for VCR, and ACC(essory) for a cable boxor satellite receiver. (See the Directions for Use manual.)HELP Button—Press when a menu is on screen to viewHELP text. The text gives a description of the displayedmenu. The HELP text will be shown every time a MENUis displayed, until you press the HELP button again.FORMAT Button—Press to quickly change the aspectratio of the viewable video. Choose from 4:3, Zoom, 16:9,and Theater.STATUS/EXIT Button—Press to display the time (afteryou have set it) and status of sound (stereo or mono), sig-nal source, and screen format. Also press to clear the TVscreen after setting or adjusting controls.VOL(ume) +, – Buttons—Press + or – until you obtainthe volume level you want.A/CH (Alternate Channel) Button—Press to choosebetween the last two channels viewed. (This is good forswitching between two sporting events, for example.)INTELLISENSE Button—Press to automatically adjustpicture convergence using Auto IntelliSense Focus.TUNER A, TUNER B, and FRONT Buttons—Press toaccess either of the two tuners in the TV’s Rear Panel or theaudio/video jacks in the TV’s Front Panel.Press the indention on the FrontPanel to access the Front PanelJacks.POWER button—With the TVoff, press and hold this button forfive seconds to see an auto-demonstration of the on-screendisplays with HELP text.Power Light—you will see ared light when the TV is turnedon.All manuals and user guides at all-guides.com