• 6 •• 6 •• Remove the water tank from its place.• Rinse and fill it with fresh water mak-ing sure that it is not filled exceedingthe (MAX) level indicated in the tank.Put the tank back in its place.Fill the tank only with fresh,non-sparkling water. Hot wa-ter or any other liquid may damagethe tank and/or the machine. Do notoperate the machine if water is notpresent: Make sure there is enoughwater in the tank.• Remove the coffee bean hopper cover.Note: The hopper may be pro-vided with different safetyfeatures according to the regula-tions of the country of use of themachine.• Slowly pour the coffee beans into thehopper.Only coffee beans must beput into the coffee bean hop-per. Ground coffee, instant coffee orany other object may damage themachine.• Replace the coffee bean hopper cover.• Insert the plug into the socket on theback of the machine.• Insert the plug of the other end of thecable into a wall socket with suitablepower voltage.OrangeBlack• Switch the power button to “I” to turnthe machine on.• Make sure the selector switch is on “” position; if necessary, turn it to theindicated position.• To turn the machine on simply press theON/OFF button.• The display indicates that the machineis priming the circuit.Note: In some cases you maybe requested to manuallyprime the circuit. For this operationsee section “Control Panel Display”.• The display shows the ON/OFF icon.OrangeThis cycle allows rinsing the coffee circuitswith fresh water.The cycle is carried out:• At machine start (with cold boiler)• After priming the circuit (with coldboiler)• During the Stand-by preparation phase(if a coffee product has been brewed)• During the turning off phase afterpressing the ON/OFF button (if a cof-fee product has been brewed).A small amount of water will be dis-pensed to rinse and heat all the machinecomponents; in this phase this icon isdisplayed.Wait for the cycle to finish automatically.You can stop dispensing by pressingeither the coffee button and/or theON/OFF button.RINSE/SELFCLEANING CYCLE