Philips Salon Multistylist HP4696 Ower's Manual

2 Take a lock of hair and wind it round the brush (Fig. 7).3 Remove the brush from your hair after 5 to 10 seconds. Let the waves cooldown before combing, brushing or finger-combing the hair into its final style.`Ringlets1 Connect the spiral attachment to the handle. Make sure that the stand ispointing downwards.2 Take a lock of hair, open the clip by pressing the lever and place the lockbetween the barrel and the clip (Fig. 8).3 Release the lever and slide the barrel to the end of the lock. Then wind thelock round the barrel following the spiral profile. Make sure that the end ofthe lock is wound in the required direction.4 Open the clip after 5 to 10 seconds and remove the barrel from the hair.Let the ringlets cool down before combing, brushing or finger-combing thehair into its final style.Crimps1 Connect the crimping/straightening attachment with crimping plates to thehandle (Fig. 9).2 Take a lock of hair (max. 5 to 6 cm wide), open the attachment by pressingthe lever and place the lock between the plates of the crimping/straighteningattachment. Start crimping at the roots (Fig. 10).3 Keep the plates locked for 5 to 10 seconds.4 Open the attachment by pressing the lever and place a lower section of thesame lock of hair between the plates. Make sure there is an overlap. Repeatthis process until you have reached the end of the lock.5 Let the crimps cool down. Do not brush or comb the crimps, as this wouldruin them.The waves, curls and crimps will disappear if your hair gets wet (for instance whenyou wash it). You can also use the straightening plates to make them disappear.Sleek look1 Open the crimping/straightening attachment. Remove the plates one by one bygrabbing their cool tips and pulling them out of the attachment (Fig. 11).2 Turn the plates round and slide them back into the attachment (Fig. 12).Make sure that the edges of the plates are inserted properly into the grooves.3 You have now turned the crimping attachment into a straightening attachment.Connect the attachment to the handle and follow the same procedure asfor creating crimps.You can also straighten the hair by slowly sliding thestraightening attachment down the lock.4 Let the sleek hair cool down before combing or brushing the hair.CleaningAlways unplug the appliance before cleaning it.Never rinse the appliance with water.Place the styler on the stand of the attachment in a safe place and let it cooldown.Clean the appliance and the attachments with a small brush or a dry cloth.StorageAlways unplug the appliance before storing it.Place the styler on the stand of the attachment in a safe place and let it cooldown.Do not wind the mains cord round the appliance.ReplacementIf the mains cord is damaged, it must be replaced by Philips, a service centreauthorised by Philips or similarly qualified persons in order to avoid a hazard.Always return the appliance to a service centre authorised by Philips for examinationor repair. Repair by unqualified people could cause an extremely hazardous situationfor the user.EnvironmentDo not throw the appliance away with the normal household waste at the endof its life, but hand it in at an official collection point for recycling. By doing thisyou will help to preserve the environment (Fig. 13).Guarantee & serviceIf you need information or if you have a problem, please visit the Philips website atwww.philips.com or contact the Philips Customer Care Centre in your country(you will find its phone number in the worldwide guarantee leaflet). If there is noCustomer Care Centre in your country, turn to your local Philips dealer or contactthe Service Department of Philips Domestic Appliances and Personal Care BV.TroubleshootingIf problems should arise with your styler and you are unable to solve them by meansof the troubleshooting guide below, please contact a Philips service centre or thePhilips Customer Care Centre in your country.,,,,,www.philips.comu4222.002.6848.1HP4696/07 Salon MultistylistProblem SolutionThe appliancedoes not workat all.Perhaps there is a power failure or the socket is not live.Check if the power supply is working. If it is, check whetherthe socket is live by plugging in another appliance.Perhaps the appliance overheated and switched itself off.Unplug the appliance and let it cool down for a few minutes.Make sure that the voltage indicated on the appliancecorresponds to the local mains voltage.Perhaps the mains cord of the appliance is damaged.The mains cord must be replaced by Philips, a service centreauthorised by Philips or similarly qualified persons in order toavoid a hazard.The styling resultsare not what youexpected.Perhaps you didn’t let the appliance heat up long enough.Let the appliance heat up until the ready dot has changedcolour.Perhaps you wound too much hair round the barrel or puttoo much hair between the plates.When using the curling attachments or the slide-on brush, donot make the locks too thick. The thinner the lock of hair, thetighter the curl will be. When using the crimping/straighteningattachment, make sure the locks are no wider than 5 to 6 cmfor a good result.Perhaps you didn’t leave the styling attachment in your hairlong enough.Keep the styler in your hair for 5 to 10 seconds, dependingon the thickness of your hair.

/ 2

Related manuals for Philips Salon Multistylist HP4607