Q-See QSC26404 User Manual

Contents

Q-See QSC26404 User Manual Manual pdf 39 page image

QSC26404 User’s Manual39Device ID:When you use the remote control to operate the DVR, you must use the device IDto select the DVR. The default device ID is “88”. If there is more than one DVR inone place, please setup different device IDs for each DVR, otherwise the remotecontrol will control all the DVRs with the same device ID at the same time.In “Display” menu, move “Active Frame” to the device ID edit box, in the editstatus, you can use numeric keys to input a new device ID. The device ID value isbetween 01 and 255.After you finish the modification, press the “Confirm” button to save and takeeffect or press “Cancel” to abort modification.5.4 Video Output Standard and VGA SetupVideo Output StandardThere is one VOUT BNC connector on the rear panel of the DVR. It is used toconnect with an analog monitor and can support PAL or NTSC video output. You canmodify the video output standard to match video input.In “Display” menu: There is a list box named “Video Output Standard”, you canuse【】【】key to select PAL or NTSC video output.VGA setupThere is one VGA interface on the rear panel of the DVR. You can use it toconnect with a VGA display. You can define VGA resolution and refresh frequency inthe “Display” menu.The following options are available: 1280*1024/60Hz,1024*768/60Hz,800*600/60Hz. You can use【】【】keys to select.Press “Confirm” button to save or “Cancel” to abort.