Q-See QSD2308L User Manual

Also see for QSD2308C8-250: Quick start guide

Contents

QSD2308L/QSD2316L DVR User’s Manual20STEP4 Select alarm out and recording channels. It can trigger any alarmout and cameras to record once motion is detected.STEP5 Enable or disable Buzzer on board. Select speed dome (PTZ) andenable preset or auto cruise. Press OK to saveSTEP6 Set Hold time. It is the interval time between two consecutivemotion events. If a second motion event is detected during the Hold time, it isrecognized as a continuation of the first motion event. If a second motion isdetected after Hold time, this motion and the previous are recognized as twodifferent motion events.STEP7 Click OK to save settingsSTEP8 Enter SCHEDULE configuration. Select Motion and relativecameras to set, refer to 3.3.3 Schedule recording.Note: About preset and auto cruise, users can only select one or the other.The actual post alarm record time equals Hold time in RECORD and Hold time in MOTION3.3.5 Alarm RecordingThis unit supports recording channels and PTZ linking after alarm.STEP1 Enter ALARM configuration, see Fig 3.13 Sensor Alarm Setup.Select camerasFig 3.13 Sensor Alarm SetupSTEP2 Enable Detection first. Set Device type.STEP3 Enter Trigger configuration. Set alarm out, recording cameras andlinked PTZ, referring to 3.3.4 Motion Detection Recording STEP4-5STEP4 Set Alarm in hold time. It is the interval time between the twoadjacent efficient alarms. This is similar with Hold time in MOTIONconfiguration.STEP5 Set Alarm out hold time and Buzzer hold time. Click OK to savesettingsSTEP6 Enter SCHEDULE configuration. Select Sensor and relativecameras to set, referring to 3.8 Schedule Setup.Note: About preset and auto cruise, users can only select one at same time.The actual post alarm record time equals Hold time in RECORD and Hold time in MOTION