More the key to each sub-menu and press enter for settingMachines address:Note:Modify the administrator PIN code:Operator pin code:Note:HDD format:Warning:Default Setup:EXIT:.Time:Machine's serial number:a). When you have adjusted the year, month and day, the time will appeared automatically..b). Scope of input number is from 000 to 999 .000 when the machine leaves the factory. You need to inputthis number when the system is running.c).d).e).fMove the cursor where you want to make the changes and press enter for adjusting or type inthe numbers using the remote controlMachine's serialnumber already toEnter manually the machine address here. Machine address could be theaddress of the place being monitored thru this system. Move the cursor to the "address" lineand press enter to be able to enter the address and press enter again when finished. Use theremote control to enter the numbers and letters. The number keys could be used for letterssimilar to the keys on a standard telephone. For example "2" represents 2abc and likewise.The length input words 8 characters or 4 words.). Please press enter to get into the setting interface of theadministrator pin code! You can press the number keys on the remote control to enter the newpin code .Please note that only the administrator has the authority to change the pin code.g). Press enter to get into the setting interface of the controller's pin code.You can press the number key on the remote control to any pin code corrections. Press theEnter key to save this setting.Please memorize your pin code and save it in a secure place to avoid it getting into thewrong hands.h). Use this function to format the Hard drive.All the data on the Hard drive will be lost.i). This function will reset the system to factory settingsj). This function takes you back to the Main Menu.Video System: The video system can be changed from NTSC to PAL and vice versa using the leftand right arrow keys on the remote.Arrowisshould bemake'' '' '' '''' ''presetYou have two options "Open" & "Close" When "Open" is selected, it willallow recording continuously even after the hard drive is full and video will be recording inFIFO (First-in-first-Out) format; When "Close" is selected, it will stop the recordingfunction once the hard drive is full.HDD overwrite:-e11-LCD WITH BUILT-IN DVR USER MANUALLCD WITH BUILT-IN DVR USER MANUAL-e12-3.2.3 System On and OffWhen the system is under monitoring state, please press twice of the 【on/off】button in thecontrol unit if you want to turn off the system, system will change into standby state fromrunning state when it is off;If you want to restart the system, please press the 【on/off】buttonthe remote control.If the system is under recording state, turn off or and then turn on the power tomake the machine enter into standby state , the machine will start automatically, the recorded fileswill redisplay its chapters.Note: The turn off operation can be also done when machine is under recording andplaying state.remoteTheonpower ,beunplug chord3.3 Properties Setup of the systemWhen the system is running, press 【setup】 button to enter into the OSD main g menu managedby host machine, move the 、 、 、 directional buttons the,Press【ENTER】 , and will be explained.remote control unitto go to the desired menu to enter into each menuthe next section'' '' onby one3.3.1 System SetupMove the cursor to the position of【System setup】(the color of the characters turns to blue withwhile bottom),Press【ENTER】button to enter into its setting interface, fter entering intothe sub-menu, highlight the items with cursor keys to change the value.ATime: 2006--03--30. 09:33:08 FridayMy Number : 000My Address:HDD Overwrite: OpenSystem : ★PAL NTSCPassword Enable: Yes NoAdmin-Pwd-Modify Operate-Pwd-ModifdHDD FormalDefault SetupReturnSystem settings★PDF created with pdfFactory trial version www.pdffactory.com