Q4 audio DPI 10 User Manual
               | |
DPI SERIES USER MANUAL54.1 Unpacking the unit4. Setting up the amplifierDPI amplifiers are packed in a strong cardboard box that pro-tects it during transport. In case you ever need to ship the ampli-fier again it is best to pack it using the original packaging materials.Therefore it is advised to save all packaging materials.The packaging has been specially studied for low load to theenvironment. The individual packaging materials can be easilyseparated and recycled.Please inspect the unit carefully for any signs of damageincurred during transport. This DPI amplifier has undergonestringent quality control inspection and tests at the factory. Itleft in perfect condition. If damage is found notify the transportcompany immediately.It is important to immediately mount the fanguard that isincluded in the box. It is an integral part of the electrical safetyprovisions of the unit.When repacking the unit, use the same packingarrangement as shown in the picture. Make sureto remove the fanguard. Place it on the side of theunit, between the two side buffers. This protects thefanguard during transport.Warning: Before continuing the installa-tion of the DPI amplifier, mount the fan-guard on the front of the unit.READY / PROTECTSIGNALBRIDGECLIP / NLRCH 2 -dBCH 1 -dBTEMP LIMIT / TCLSUPPLY OVL0246810121402468101214PROFESSIONAL CLASS-D POWER AMPLIFIERPOWER ONREMOTEACTIVE CALL10 EXAMINE EQUIPMENT CAREFULLY FORSHIPPING DAMAGE. IF DAMAGE ISFOUND NOTIFY THE CARRIER WHOMADE DELIVERY. DEMAND ANINSPECTION AND A SIGNED DAMAGEREPORT.THIS PACKAGING IS MADE FROM FULLYRECYCLABLE MATERIALS. KEEPPACKAGING FOR FUTURE USE ORDISPOSE OF PROPERLY.DPI SeriesUser manualPrelimenaryProfessional Power AmplifiersRDPI 10 2 x 300 WDPI 15 2 x 500 WDPI 20 2 x 800 WDPI 30 2 x 1.100 WDPI 40 2 x 1.500 WSIGNALoo4681012141824REMOTEACTIVE CALLPlace the two tabs of the fanguard in the corresponding holeson the right of the unit. Push the fanguard against the front paneland secure it by turning the /4 turn lock 90° clockwise.DPI series amplifiers are equipped with two cooling fans withfront to rear airflow. When installing the amplifier, allow for amplespace behind the amplifier to ensure sufficient airflow, especiallyif the amplifier is operated in a rack system. This avoids thermallimiting of the output power or, in severe situations even shut-offby the thermal protection system.The fancover can be easilly removed by turning the /4 turnlock 90° counterclockwise and pulling it off the frontpanel, leftside first.The standard air filter delivered with the amplifier is a black,8mm thick reticulated polyurethane foam with a density of 20PPI.The filter can be easilly cleaned by rinsing it with water. Let it drythouroughly before mounting it back onto the amplifier.In case you need to replace the filter use only the prescribedmaterial and thickness or contact your distributor for a replace-ment.Do not use the amplifier without the airfilter in place.Regular cleaning of the filter eliminates dust buildup inside theunit.4.2 Attaching / removing the fancover!! |
Related manuals for Q4 audio DPI 10
manualsdatabase
Your AI-powered manual search engine