QCA Spas QCA Paradise Series Owner's Manual
NOTE: Not maintaining your water can result indamage of your spa jets, filter, etc. Thisdamage, due to incorrect water maintenance, isnot covered under warranty.Filter MaintenanceAs with any water filtering system, the filtercartridges may become clogged with particles orwith calcification that will result in reduced waterflow. In your QCA Spa, it is important to maintaina clean, unobstructed filtering system. This notonly provides the maximum performance from thehydrotherapy jets, but allows the 24 hour filtrationsystem to function effectively. We recommend thefilter cartridges be cleaned (either spraying cleanwith water or soaking to dissolve minerals)EVERY MONTH.WARNING: Failure to maintain the cartridges ina clean, unobstructed manner will result in reducedwater flow through the heater assembly which maycause the Heater High Limit Thermostat to "trip".If this high limit "trip" occurs during sub-freezingtemperatures and goes unnoticed, the spa watermay freeze. Any damage to the spa (fromfreezing), which is a direct cause of poormaintenance, will not be covered by warranty.Removing the Filter CartridgeThe cartridge of the in-line filter must be removedfor cleaning. This is accomplished as follows:1. Remove filter lid.2. Twist and lift built-in chemical dispenser andremove the cartridge.3. Remove the filter cartridge from the housingand clean, or replace it with a new cartridge.Cleaning the Filter Cartridge1. Hold the cartridge in an upright position andspray downward into the pleats of the fabricwith a garden hose to flush away debris.Cleaning will be easier if the garden hosenozzle can be adjusted to a single jet spray.2. After hosing off the cartridge, it is highlyrecommended that the cartridge be allowed tosoak in a filter-cleaning solution availablethrough your local dealer. Soak the cartridgefor 24 hours to remove body oils and bodylotions that become impregnated in thecartridge fabric during filtration. Rinse thecartridge thoroughly before placing it back inthe filter housing.NOTE: If two filter cartridges are available, it isrecommended to allow filter cartridge to drybefore new usage.3. If the cartridge is coated with hard, solidmaterial, it may indicate a calcium build-up onthe fabric. This build-up can be removed bysoaking the cartridge in proper cartridgecleaning solution available through your QCAdealer. When using this solution, followinstructions provided on label.4. If the cartridge is coated with algae or bacteria,it should be soaked in a solution of one partchlorine and four parts water in a plasticcontainer. As a safety precaution, rubber glovesshould be worn while handling this solution.Brushing the solution into the fabric pleats mayalso help remove algae or bacteria. Rinse thecartridge thoroughly before placing it back intothe filter housing.Observe manufacturers recommended safetyprocedures when using acid or chlorine. Alwaysrinse the cartridge thoroughly after applying thesesolutions.5. Clean the filter housing and filter housing O-ring. Lubricate the O-ring with siliconelubricant.6. Return the filter cartridge to the housing andreplace the housing lid.Vacation Care InstructionsIf you plan to be away, follow these instructions tomaintain the water quality:Short Time Periods (3-5 Days):1. Adjust the pH by following the instructionsoutlined in the water quality and maintenancesection.2. Sanitize the water by following the "super-chlorination" procedures and lock your thermalcover in place using the tie-downs.3. Upon your return, sanitize the water(superchlorinate, if necessary) and balance thepH.IMPORTANT NOTE: Spa water oxidizers such asdichlor chlorine maintain their level ofeffectiveness substantially longer in cool waterthan in hot water.Long Time Periods (4-15 Days):Prior to leaving:1. Adjust the pH as required.2. Sanitize the water by following the SUPER-CHLORINATION procedures.3. Upon your return, check the level of sanitationof your spa water. If the chlorine test reads "O"and you have been gone an extended period oftime, SUPER-CHLORINATE the spa water toensure all organisms or algae are oxidized.Turn the Temperature Control clockwise toreturn it to the original setting. The spa waterwill be safe for you to use once the FreeChlorine Residual has dropped below 5.0 ppm.Prevention of FreezingThe QCA Spa has been designed and engineeredfor year-round use in any climate. The energyefficiency of the spa may decrease during thesecold periods, as the heater will cycle morefrequently. If a freeze condition is detected, the13 |
Related manuals for QCA Spas Majestic Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine