QSC Atterotech unDX2IO+ User Manual

Contents

QSC Atterotech unDX2IO+ User Manual Manual pdf 7 page image

unDX2IO+User ManualAttero Tech by QSC 2019 Page 6 614-00036 Rev 01_d2.1 – MountingA typical installation will involve mounting the wall plate into a pre mounted wall box or mounting bracket. Before starting,make sure the wall box where the unDX2IO+ is to be installed is pre-wired with a suitable cable back to a PoE-enablednetwork switch or mid-span injector. If a mid-span injector is being used, the cable should be connected to the port thatsupplies both Ethernet and power (refer to the devices manual if unsure which port is which).*Note: All Attero Tech by QSC products are tested using UTP cabling and it is recommended that UTP cabling be usedwhen installing them. STP cabling can be used for installation though care must be taken not introduce grounding issuesinto the system by doing so.Attach the network cable from the switch/mid-span injector to the Dante port of the Dante unDX2IO+. If the switch ormid-span injector is already running and PoE is enabled, the unit should power up and the green ID LED on the front ofthe device should turn on.With the cable attached, carefully place the unDX2IO+ into the wall box taking care to not trap the cabling. Once full inplace, secure it with the screws provided. Once the unit is secured in the wall box, fit the Decora plate and secure it withthe screws provided with it.The figure below shows the installation of the companion passive XLR audio input plate and the unDX2IO+.Figure 2 - unDX2IO+ Installed with unXP2I (Rear View)