QSC CMS-5000 Quick Start Manual
Also see for CMS-5000: User manual
          | |
3TD-001577-01-BMaintenance and RepairWARNRNG!: Advanced technology, e.g., the use of modern materials and powerful electronics,requires specially adapted maintenance and repair methods. To avoid a danger of subsequent damageto the apparatus, injuries to persons and/or the creation of additional safety hazards, all maintenanceor repair work on the apparatus should be performed only by a QSC authorized service station or anauthorized QSC International Distributor. QSC is not responsible for any injury, harm or relateddamages arising from any failure of the customer, owner or user of the apparatus to facilitatethose repairs.LITHIUM BATTERY WARNINGWARNRNG!: THIS EQUIPMENT CONTAINS A NON-RECHARGEABLE LITHIUM BATTERY. LITHIUM ISA CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER OR BIRTH DEFECTS. THENON-RECHARGEABLE LITHIUM BATTERY CONTAINED IN THIS EQUIPMENT MAY EXPLODE IF IT ISEXPOSED TO FIRE OR EXTREME HEAT. DO NOT SHORT CIRCUIT THE BATTERY. DO NOT ATTEMPTTO RECHARGE THE NON-RECHARGEABLE LITHIUM BATTERY. THERE IS A RISK OF EXPLOSION IFTHE BATTERY IS REPLACED BY AN INCORRECT TYPE. BATTERY REPLACEMENT IS PROHIBITED!FCC StatementRNOT!: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of theFCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, usesand can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correctthe interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.DCI/FIPS Security ComplianceThe CMS-5000 is a FIPS-140-2 Certified device. It contains cryptographic devices and keys and must be handled correctly while in use andwhen removed from service. The end user of the CMS-5000 is classified by FIPS as a Cryptographic Officer and is responsible for placing andmaintaining the projector system into a FIPS approved mode. In this capacity you agree to the following guidelines:1. Do not attempt to dismantle or reverse engineer the device. Any attempt to gain access to the modules enclosed in the secure environmentmay result in loss of functionality and will void any warranty.2. Ensure that at least two tamper seals are present on the CMS-5000 security module. Any attempt to remove, alter or replace the tamper labelseals on the CMS-5000 secure enclosure will void the warranty.3. The user assumes responsibility to change the standard passwords installed by the factory.4. The user assumes responsibility for the protection of keys (KDMs) and the protection of passwords used to access the CMS-5000.5. Ensure that one or more external tamper seals are affixed to the surface between the CMS-5000 and the projector body.6. Perform or monitor the marriage between the CMS-5000 and the projector.7. At end-of-life, perform or monitor the physical removal of the battery by separating the battery from the printed circuit board. The battery andthe CMS-5000 should be disposed of in accordance with local or national legislation. |
Related manuals for QSC CMS-5000
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine