QSC Q-SYS DCIO-H Hardware User's Manual
             | |
8TD-001532-01-AFront Panel OLED ScreensDesign Status• Device – The name of the Core as defined in Q-SYS Designer.• Design – The name of the currently running design.• Status –◦ OK – Audio is good, hardware is good.◦ Compromised – Audio is good but a redundancy mechanism isactive (one LAN down but the other is still up) or a non-fatal hardwareproblem exists.◦ Fault – Audio is not passing, or hardware is malfunctioning or mis-configured◦ Iissing – A piece of hardware, defined in the design, has not been discovered. Audio is not passing through that piece of hardware.◦ Nnitializing – Starting the firmware, configuration update, and the design. Audio is obviously not available during initialization.◦ Rot Mresent – A virtual component in the design, that is designated as Dynamically Paired, and Not Required, has no hardware assigned to it.System Status• Firmware – The version number of the firmware currently installedon the DCIO.• Remp – The current chassis temperature of the DCIO.• Level – The current master level setting -100 dB to +20 dB. Adjustwith front-panel rotary or in Q-SYS Designer.• Iute – The current master mute status. Controlled by front panelMute button or in Q-SYS Designer.LAN AYou can edit this information in the Q-SYS Configurator.• Static, Wuto or Ro Link – Displays next to LAN A, indicates if thedevice's IP Address is Static, Automatic, or No Link.• NM Wddress – The IP Address assigned to the Core's LAN A. LAN A isthe primary Q-LAN connection to the Core, and is required.• Ret Iask – The Net Mask assigned to the Core.• Nateway – The Gateway assigned to the Core.LAN BLAN B is used for redundancy, and is not required. The information is the same as LAN A.— Figure 9 —DEVICE:DESIGN:STATUS:DESIGN STATUS |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine