QUBINO Flush 2 relay User Manual
                                                           | |
Contents
| 
EN.4010. Adding the device to a Z-Wave network (Inclusion)AUTOMATICALLY ADDING THE DEVICE TO A Z-WAVE NETWORK (AUTO INCLUSION)1. Enable add/remove mode on your Z-Wave gateway (hub)2. Connect the device to the power supply (with the temperature sensor already connected –sold separately*).3. Auto-inclusion will be initiated within 5 seconds of connection to the power supply and thedevice will automatically enrol in your networkMANUALLY ADDING THE DEVICE TO A Z-WAVE NETWORK (MANUAL INCLUSION)1. Enable add/remove mode on your Z-Wave gateway (hub)2. Connect the device to the power supply (with the temperature sensor already connected*)3. Toggle the switch connected to the I1 terminal 3 times within 3 secondsORIf the device is powered by 24 V SELV supply, press and hold the S (Service) button between 2and 6 seconds4. A new multi-channel device will appear on your dashboard*If connecting the temperature sensor, switch off the power supply and make sure the deviceis excluded from your network BEFORE connecting the sensor.ⓘ Make sure the device is excluded from your network before connecting the temperaturesensor. Switch off the power supply, connect the temperature sensor, and re-include the deviceto your network. |
Related manuals for QUBINO Flush 2 relay
manualsdatabase
Your AI-powered manual search engine