Qlogic 200 Series Quick Start Manual

Also see for SANblade 2300 Series: Quick start guide User guide

Contents

Qlogic 200 Series Quick Start Manual Manual pdf 11 page image

7 FC0054505-01 C2 InstallationThis chapter describes how to install and configure the QLogic Host Bus Adapterin three simple steps: Step 1. Install the Hardware Step 2. Install the Adapter Driver Step 3. Install QConvergeConsole ®Step 1. Install the HardwareTo install the adapter hardware, you need to open the computer and locate theappropriate bus slot. If necessary, consult your computer system manual forinstructions to remove the computer cover.Installing the QLA2xx, QLA23xx, QLA24xx, QLE2xx, QLE236x,QLE24xx, and QLE25xx AdaptersTo install the adapter hardware:1. Power off the computer and all attached devices such as monitors, printers,and external components.2. Disconnect the power cable.3. Remove the computer cover and find an appropriate empty bus slot.CAUTIONKeep the adapter in the antistatic bag until installation. The Host BusAdapter contains parts that can be damaged by electrostatic discharge(ESD). Before handling the Host Bus Adapter, use standard methods todischarge static electricity. Place the Host Bus Adapter on the bag whenexamining it. Retain the bag for future use.NOTEThe QOE2562 installation procedure differs from these adapter models; see“Installing the QOE2562 Adapter” on page 8