13 – Command ReferenceFirmware Install13-20 59183-01 ASFirmware InstallDownloads firmware from a remote host to the switch, installs the firmware, thenresets the switch to activate the firmware. This is disruptive. The commandprompts you for the following: The file transfer protocol (FTP or TFTP) IP address of the remote host An account name and password on the remote host (FTP only) Pathname for the firmware image fileAuthority Admin sessionSyntax firmware installExamples The following is an example of the Firmware Install command using FTP:SANbox #> admin startSANbox (admin) #> firmware installThe switch will be reset. This process will cause a disruptionto I/O traffic.Continuing with this action will terminate all management sessions,including any Telnet sessions. When the firmware activation is complete,you may log in to the switch again.Do you want to continue? [y/n]: yPress 'q' and the ENTER key to abort this command.FTP or TFTP : ftpUser Account : johndoeIP Address : 10.0.0.254Source Filename : 6.7.00.11_mpcAbout to install image. Do you want to continue? [y/n] yConnected to 10.0.0.254 (10.0.0.254).220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.331 Password required for johndoe.Password: xxxxxxxxx230 User johndoe logged in.bin200 Type set to I.verboseVerbose mode off.This may take several seconds...The switch will now reset.Connection closed by foreign host.
