3–InstallationInstalling the iSR6200 Router3-12 ISR651101-00 DTo configure the router using the command line interface:1. Open a command window according to the type of workstation andconnection: Ethernet (all platforms): Open a Telnet session with the default routerIP address and log into the router with the default account name andpassword (guest/password):telnet 10.0.0.1username: guestpassword: ******** Serial, Windows: Open the HyperTerminal application on a Windowsplatform as follows:a. From the Windows Start menu, click Programs, point toAccessories, Communications, and then click HyperTerminal.b. Select the connection you created earlier, and then click OK. Serial, Linux: Open a command window and enter the followingcommand:minicom2. Open an admin session and enter the commands to set up both iSCSI portsand the management interface. (See the iSR6200 Router CLI User's Guidefor command descriptions.)QRouter #> admin startPassword : ******Router (admin) #> set mgmt………………………QRouter (admin) #> set iscsi 1………………………QRouter (admin) #> set iscsi 2………………………Connecting Cable Devices to the RouterConnect cables to the SFP transceivers and their corresponding devices. Devicescan have SFP (or small form factor, SFF) transceivers or GBICs. Choose the fiberoptic cable with the connector combination that matches the device beingconnected to the router:
