Qsonica Q700 Operation Manual
Also see for Sonicator Q700: Operation manual
                              | |
Rev. 6-1252. WarningsPlease read the manual in its entirety. Necessary instruction and guidance are provided to helpensure the successful operation of this device.Your new Ultrasonic Liquid Processor has been designed, built and tested to assure maximumoperator safety. How ever, no design can completely protect against improper use that may lead tobodily injury and/or property damage. For total safety and equipment protection, read theinstruction manual carefully before attempting to operate this equipment. Observe the follow ingWARNINGS: High voltage is present in the generator (pow er supply), converter and high frequency cable. There are nouser-serviceable parts inside any of these devices. Do NOT attempt to remov e the generator cover orconverter case. Do NOT touch any open cable connections on the unit w hile the pow er is turned ON. Do NOT operate generator w ith converter disconnected from high voltage cable. High voltage is present inthe cable and may pose a shock hazard. Do NOT attempt to disconnect the converter high voltage cable w hile the unit is running. The generator must be properly grounded w ith a 3 -prong plug. Test electrical outlet for proper groundingbefore plugging in unit. Install the ultrasonic processor in an area free from excessive dust, dirt, explosive or corrosive fumes andprotected from extremes in temperature and humidity. Do not place the Generator w ithin a Fume Hood. Hearing protection is highly recommended. It is recommended that a sound abating enclosure or earprotection be used w hen operating the Ultrasonic Processor NEVER immerse the converter in liquids of any kind, or let condensed moisture or liquid drip into theconverter. NEVER grasp an activated horn or probe. It can cause severe burns and tissue damage. NEVER allow a probe to vibrate in air. NEVER hold or clamp the converter by the front driver or by the horn itself. This can cause permanentdamage to the system. Support the converter by only clamping around t he converter housing (upperportion). If needed air cool the convertor w ith dry compressed air. Do NOT allow the tip of a vibrating horn or probe to touch the counter top or any other hard surface. Itcould damage the probe, overload the generator, or damage the surface. Avoid touching the bottom or sides of a glass or plastic container w ith an activated probe. It could crackor shatter the glass or melt the plastic. Turn OFF the pow er sw itch, unplug the generator and disconnect the pow er cord from the back of thegenerator before attempting to replace the fuses. Inspect high frequency cable for cracks in the protective outer jacket. Do not operate unit w ith a damaged cable. Doing so may cause serious injury. In case of AC pow er loss, w ait 3 minutes minimum before reapplying pow er. Do not turn off AC mains pow er w hile running a horn. Stop sonication via touch screen prior to stoppingpow er. |
Related manuals for Qsonica Sonicator Q700
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine