Qtx B12P User Manual
      | |
154.013UK User ManualDMX operationIn order to access the DMX functions, the DMX start address will need to be set on thecontrol panel (or from the remote control – see below).When the display shows “”, this means that the B12P is operated by channels 1-8 asdetailed on the previous page. When the display shows “”, this means that the B12P isoperated by channels 203-210.The start address can be anywhere between 001 and 512Standalone operationThe B12P can be operated without external control by selecting one of the Auto or customstatic colour settings from the control panel menu. These are Shown in the Internal Settingssection on page 3 of this manual.Internal settings can also be selected via the included IR remote control as detailed below.As supplied, the remote handset has a clear plastic tab inserted which should be removed toactivate the CR2025 button cell. Point the handset toward the front of the B12P unit at arange of no more than 5m for remote control.Master/slave operationA B12P fixture operating in one of the standalone modes may be connected onto furtherB12P units by DMX lead (XLR-XLR) as a master unit. The slave units must be set to “IP”mode to mimic the operation of the master unit.The LED display will show “IP” followed by two digits, which is the IP number. The IPnumber is not used in the B12P and any setting from IP01 to IP64 will operate as slavemode (IP numbers are only used in different types of fixtures)When IP mode is selected, the B12P will mimic any DMX input from another B12P operatingin standalone Auto or Static Colour mode.1 Power on/off 9 Auto 4 sound activated2 Auto 1 static colours 10 Auto 2 colour change3 Auto 3 colour fade 11 Auto 5 strobe4 Static colour - 12 Static colour +5 Program speed - 13 Program speed +6 DMX address - 14 DMX address +7 IP slave ID - 15 IP slave ID +8 IP slave mode select 16 DMX mode select |
Related manuals for Qtx B12P
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine