151.603UK User ManualStandalone operationThe GOBO DERBY can be operated without external control by selecting one of the Internal show modesfrom the control panel menu. These are Shown in the Internal Settings section on the previous page.Internal settings can also be selected via the included IR remote control as detailed below.As supplied, the remote handset has a clear plastic tab inserted which should be removed to activate theCR2025 button cell. Point the handset toward the front of the GOBO DERBY unit at a range of no more than5m for remote control.Master/slave operationAn GOBO DERBY fixture operating in one of the standalone modes may be connected by DMX lead to controlfurther GOBO DERBY units by pressing the MENU button until “” is displayed, pressing enter andselecting “” to set it as the master unitThe slave units must be set to “” mode to mimic the operation of the master unit.In this mode, the slave GOBO DERBY units will mimic the master GOBO DERBY working in standalone mode.DMX operationIn order to access the DMX functions, the DMX start address will need to be set on the control panel (orfrom the remote control as detailed above).When the display shows “”, this means that the GOBO DERBY is operated starting from DMX address 1.When the display shows “”, this means that the GOBO DERBY is operated starting from DMX address203. The start address can be anywhere between 001 and 512.There are 2 DMX modes – 2 channel and 10 channel – which are detailed on the following pages.Standby Temporarily disables light outputDMX - Not used -Show 1 – Show 4 Select internal show modeShow 5 – Show 8 - Not used -LED Color LED colour selectLED Random Random LED colour selectLaser Color Laser colour selectLaser Random Laser random LED colour selectSound ON Sound activation onSound OFF Sound activation off (auto mode)Speed - Reduce effect speedSpeed Default (medium) effect speedSpeed + Increase effect speed