Qtx QR10PA Manual

Also see for QR10PA: User manual User manual

Contents

Qtx QR10PA Manual Manual pdf 3 page image

178.840UK User ManualControl panelPowering upYour new QR10PA portable PA unit may arrive with you with the internal battery charged. Before connecting to the mainswith the supplied power adaptor, switch the unit on and check the POWER LED. If it is green, there is charge in thebattery. If it is red, then you will need to charge the battery before using away from a mains supplyConnect the QR10 PA unit to the mains using the supplied power adaptor. You may otherwise opt to connect the DCinput jack to an external 12-15Vdc supply, such as a car battery, or use the internal battery if charged.When not in use but connected to the mains, if the POWER switch is in theoff position, the internal battery will be re-charged from the mains supply. This can be observed by the CHARGE LED which will light orange when charging. Whenfully charged, the CHARGE LED will change to green.Initial setupTurn all VOLUME & ECHO controls down (anti-clockwise) and turn the POWER switch on (the power LED should light).BASS and TREBLE (5, 16) controls should remain pointing vertically (12-o-clock position). Turn up the main VOLUMEcontrol (14) part way and switch VCV (15) off. Your QR10PA unit should now be ready to operate.VHF Neckband MicrophoneConnect the neckband microphone to the bodypack via the 3.5mm jack, slide open the bodypack and insert the suppliedAA batteries, observing the correct polarity. With the VHF WIRELESS MICROPHONE VOL (6) control turned down, pressthe VHF ON/OFF button (17) in so that the VHF POWER LED (18) lights.Switch on the beltpack transmitter fully (2 clicks as the centre position is “MUTE”) – the RF LED should light as a result.Turn up the volume control on the beltpack fully – this can be turned down later if required. If the LED on the transmitterlights dimly, change the battery.Gradually increase VHF VOL control, testing the neckband microphone for output through the speaker.Take care not to incur “feedback” (howling or screeching sound through the speaker) by keeping the microphone asensible distance from the speaker and pointing away from the speaker so that it doesn’thear the speaker output.Turning the ECHO control (3) clockwise introduces a pre-set echo function for singing and special effects. BASS andTREBLE (5, 16) can be cut by turning anti-clockwise or boosted by turning clockwise.When not in use, switch the beltpack transmitter off and remove the batteries if not being used for long periods.1 USB port2 SD/MMC card slot3 ECHO level4 Wired MIC volume5 TREBLE EQ6 VHF Mic volume7 LINE IN 2 x RCA8 Wired MIC.2 input 6.3mm jack9 Wired MIC.1 / guitar input 6.3mm jack10 Smart phone / aux input stereo 3.5mm jack11 MIX OUT line output 2 x RCA12 Media player LCD display & IR receiver13 Media player mode & transport controls14 Main volume15 VCV talkover on/off16 BASS EQ17 VHF wireless receiver on/off18 VHF wireless receiver power & RF signal LEDs19 Battery charge & power LEDs20 Power on/off21 DC power input jack

/ 5

Related manuals for Qtx QR10PA