Quadra-Fire 2100 Millennium Owner's Manual

Also see for 2100 Millennium: Owner's manual Installation, operation and maintenance instructions

Contents

Quadra-Fire 2100 Millennium Owner's Manual Manual pdf 20 page image

2100 ACT Millennium Wood StovePage 20 250-6931C November 3, 2004RDOOR HANDLE ASSEMBLY1. Remove all ash from the firebox, and extinguish all hot embers before disposal into a metal container.2. With a 3/16” allen wrench, remove the 2 front secondary combustion tube retainer bolts on the secondary air channel underthe end of the front tubes. See Figure 20A. NOTE: Soak the bolts with penetrating oil for at least 15 minutes beforetrying to remove them.3. To remove the secondary combustion tubes, slide the tube to one side until one end is out of its hole. Then, while lifting that end ofthe fiber board, pull the tube up over the secondary air channel and out of the hole at the other end.4. Slide fiber board forward to front of stove, tilt down and slide through the door. See Figure 20B.5. To install the fiber board baffle, repeat steps 2 through 4 in reverse. Be sure that the fiber board baffle is pushed back fully.NOTE: The baffle in the 2100 Millennium is 2700° Fiber Board. Removing hardware exposed to combustion processes can befrustrating. If your reason for removing the baffle is simply to clean the chimney, you have alternatives which will save time and effort.Call a qualified chimney sweep or an authorized Quadra-Fire dealer for details.BAFFLE REMOVAL AND INSTALLATIONFIGURE 20B - Baffle & Ceramic BlanketFIGURE 20A - Allen wrench on retainer boltLocknutDoor Cross Section(example)Latch CamSpacingWashersSquare KeyDoor HandleSpringHandle1. Install washer on door handle shaft.2. Slide door handle through door.3. Install second washer(s) as shown.4. Install key in groove.5. Align groove in latch cam with key; slide latch cam over shaft6. Install locknut.CAUTION! DO NOT OVERTIGHTEN LOCKNUT. DOORHANDLE NEEDS TO MOVE SMOOTHLY.7. Install spring handle turning in a counter-clockwise motion todesired location on handle.GLASS REPLACEMENTReplace with 5mm ceramic glass only, Part: 832-00501 . Ensure that the fire is out and the stove is cool to the touch.2. Protect a table or counter top with padding or towels.3. Remove the door with the broken glass by lifting the door up and off of the hinges.4. Lay door face down on a table or counter making sure the handle hangs over the edge so the door lays flat, on a soft surface.5. Remove the screws from each glass retainer and remove the glass. (if screws are difficult to remove, soak with penetrating oil first).6. Center the glass with edges evenly overlapping the opening in the door, (i.e. same space top and bottom, left and right sides).7. Replace the glass retainers. Be careful not to cross thread the screws.8. Tighten each retainer just a few turns until each is secured. Check again for centering of glass in door frame. Then continue totighten each retainer alternately, a few turns at a time, until the glass is secure. DO NOT OVERTIGHTEN.9. Replace the door on the appliance.