Quadra-Fire 31I-ACC Owner's Manual

Also see for 31I-ACC: Installation manual Owner's manual Owner's manual Installation manual Owner's manual

Quadra-Fire 31I-ACC Owner's Manual Manual pdf 23 page image

February 25, 2016 7044-226C 233100-I ACCFigure 23.1 Snap Disc LocationFigure 23.2Snap DiscSnap DiscMagnetSpadeConnectorsFigure 23.3Figure 23.4The ceramic blanket and both baffle boardsand tube channel assembly can all beremoved at the same time.Baffle BaffleCeramic BlanketD. Baffl e Removal1. Remove all ash from the firebox, and extinguish all hotembers before disposal into a metal container.2. The baffle board has 2 pieces. With the ceramic blanketstill in place, slide one baffle piece over the top of other onebut still keep it all components inside the firebox. Figure23.3.3. It is easier to remove both baffle boards and ceramicblanket after the tube channel assembly has been partiallydisassembled. Follow steps 1 through 4 on page 25 forremoval of the tube channel assembly. It is not necessaryto completely remove the tube channel assembly.4. Re-install in reverse order. Be sure the baffle boards andceramic blanket are in their proper positions. Figure 23.4.C. Snap Disc Replacement1. The snap disc bracket assembly is located on top of theblower housing in the center. Figure 23.1.2. Remove the 4 hex head bolts using a 5/32 Allen wrenchfrom the blower housing and pull the housing towards you.3. Pull the snap disc and spade connectors up and out ofbracket as shown in Figure 23.2.4. Using a Phillips head screw driver, remove the 2 screwsfrom the snap disc and then remove the snap disc fromthe spade connectors. Replace with new snap disc andre-connect to spade connectors.5. Push the snap disc and spade connectors back insidebracket and re-attach the bracket to the appliance.6. Re-attached the blower housing to the appliance.